Frigidaire FFHN2740PS0 Installing Door Handles, Door Handle Mounting Instructions for Frigidaire

Page 11

INSTALLING DOOR HANDLES

Door Handle Mounting Instructions for Frigidaire

1Remove handles from carton and any other protective packaging.

2Position fresh food handle end caps over upper and lower pre-installed shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing towards the opposite door.

3While holding handle firmly against door, fasten upper and lower Allen set screws

(B) with supplied Allen wrench.

4Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door.

5Position freezer handle end caps over left and right pre-installed shoulder bolts that are fastened to the door, ensuring the holes for the set screws are facing down.

6While holding handle firmly against door, loosely tighten right Allen set screw (B) with supplied Allen wrench until there is no gap between handle and door.

7Still holding the handle firmly to the door, firmly tighten left Allen set screw (B) with supplied Allen wrench.

8Return to the right Allen set screw (B) and firmly tighten with supplied Allen wrench.

Mounting Refrigerator Handles

Mounting Freezer Handle

NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps.

Opening the opposite door while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles.

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

11

Image 11
Contents December Use &CareImportant Safety Instructions CFC/HCFC Disposal Electrical informationFeatures may vary according to model Features AT a GlanceLocation InstallationInstallation Required ToolsLeveling Freezer Drawer Level Refrigerator & Adjust DoorsTo level the cabinet using the front rollers select models Install the toe grille by fitting into placeRetighten screw Rotate door stop until it makes contact with the lower hingeLoosen the screw located on the flipper mullion hinge To adjust the flipper mullionTo remove the top hinge covers Door Removal InstructionsGetting through narrow spaces To prepare for removing the doorsRemoving Freezer Drawer Installing Freezer DrawerDoor Handle Mounting Instructions for Frigidaire Installing Door HandlesAllen set screw B with supplied Allen wrench Door Handle Mounting Instructions for Frigidaire GalleryFirmly tighten the inside Allen set screws Before Installing The Water Supply Line, You Will Need Connecting the Water SupplyTo Connect Water Supply Line To Ice Maker Inlet Valve Options may vary Setting cooling temperaturesAlarms ControlsSabbath Mode Ice maker tips Cleaning the ice makerIce maker operation & care Turning the ice maker on and offDrawers Storage FeaturesShelf features To change the position of a shelfStorage bins To change the position of an adjustable door binCrisper humidity control Deli drawerTo Remove Lower Basket Accessories varies by modelFreezer Features varies by model Dairy compartmentSpill Guard Tray should be hand washed in warm water Lift up on the rear of the lower divider and pull outIdeas for saving energy Storing Food and Saving EnergyIdeas for storing foods Understanding the sounds you may hear Normal Operating Sounds and SightsChanging the Filter Paultra Air filter select modelsReplacing your PureAdvantageTM air filter Protecting your investment Care & CleaningVacation and moving tips Occasion Tips LED Light Incandescent Lights 40-watt bulb 5305514148 Ordering Replacement LED LightsReplacing LED Lights select models To replace LED LightsCanada Before YOU CallUnited States Or too long TemperatureRefrigerator Runs too muchExclusions This warranty does not cover the following Major Appliance Warranty