Frigidaire FFHN2740PSPKG, FFHN2740PS0 Door Handle Mounting Instructions for Frigidaire Gallery

Page 12

INSTALLING DOOR HANDLES

Door Handle Mounting Instructions for Frigidaire Gallery®

1Remove handles from carton and any other protective packaging.

2Position fresh food handle end over upper and lower pre-installed shoulder bolts

(A) that are fastened into door, ensuring the holes for the set screws are facing towards the opposite door.

3While holding handle firmly against door, fasten upper and lower Allen set screws

(B) with supplied Allen wrench.

4Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door.

5Position freezer handle end over left and right pre- installed handle mounts that are fastened to the door, ensuring the holes for the set screws are facing down.

6While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied Allen wrench until there is no gap between handle and door.

7Still holding the handle firmly to the door, firmly tighten far left

Allen set screw (B) with supplied Allen wrench.

8Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.

Mounting Refrigerator Handles

Mounting Freezer Handle

NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps.

Opening the opposite door while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles.

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

12

Image 12
Contents Use &Care DecemberImportant Safety Instructions Electrical information CFC/HCFC DisposalFeatures AT a Glance Features may vary according to modelInstallation InstallationRequired Tools LocationLevel Refrigerator & Adjust Doors To level the cabinet using the front rollers select modelsInstall the toe grille by fitting into place Leveling Freezer DrawerRotate door stop until it makes contact with the lower hinge Retighten screwTo adjust the flipper mullion Loosen the screw located on the flipper mullion hingeDoor Removal Instructions Getting through narrow spacesTo prepare for removing the doors To remove the top hinge coversInstalling Freezer Drawer Removing Freezer DrawerInstalling Door Handles Door Handle Mounting Instructions for FrigidaireDoor Handle Mounting Instructions for Frigidaire Gallery Allen set screw B with supplied Allen wrenchFirmly tighten the inside Allen set screws Connecting the Water Supply Before Installing The Water Supply Line, You Will NeedTo Connect Water Supply Line To Ice Maker Inlet Valve Setting cooling temperatures AlarmsControls Options may varySabbath Mode Cleaning the ice maker Ice maker operation & careTurning the ice maker on and off Ice maker tipsStorage Features Shelf featuresTo change the position of a shelf DrawersTo change the position of an adjustable door bin Crisper humidity controlDeli drawer Storage binsAccessories varies by model Freezer Features varies by modelDairy compartment To Remove Lower BasketLift up on the rear of the lower divider and pull out Spill Guard Tray should be hand washed in warm waterStoring Food and Saving Energy Ideas for storing foodsIdeas for saving energy Normal Operating Sounds and Sights Understanding the sounds you may hearChanging the Filter Air filter select models Replacing your PureAdvantageTM air filterPaultra Care & Cleaning Protecting your investmentVacation and moving tips Occasion Tips Ordering Replacement LED Lights Replacing LED Lights select modelsTo replace LED Lights LED Light Incandescent Lights 40-watt bulb 5305514148Before YOU Call United StatesCanada Temperature RefrigeratorRuns too much Or too longMajor Appliance Warranty Exclusions This warranty does not cover the following