Frigidaire 316902315 important safety instructions To assemble the Effortless Oven Rack system

Page 8

BEFORE SETTING OVEN CONTROLS

Effortless™ Oven Rack system

Some models are equipped with a special oven rack system that automatically partially extends the oven rack from the interior oven glides to assist in easier access to your food items. This feature works whenever the oven door is opened or closed.

To assemble the Effortless™ Oven Rack system:

1.Locate all required parts. You will need the supplied oven rack (Effortless™ Oven Rack is a flat rack with a special dark coating on the left and right rack sides) and the 2 supplied chrome connector arms.

2.Open the oven door. Be sure the oven is completely cool before proceeding.

3.Place the oven rack in positions 2, 3 or 4 only (see previous page to verify positions).Be sure the rack connector brackets are at the rear of the range and pointing towards oven bottom (See Fig. 2).

4.Assemble one connector arm at a time. With the oven door open and the oven rack in place, install one end of the connector arm to the hole in the door connector bracket (Fig. 1) and the other end in the hole in the rack connector bracket (Fig. 2 and as in Fig. 3). The oven rack may need to be adjusted in or out in the rack position to match the length of the connector arm.

5.While holding the connector arm in place, twist the connector arm so the ends of the connector arm point upwards (See Figs. 4 & 5). The connector arm should now be locked into position.

6.Repeat steps 4 and 5 for the other connector arm.

7.Once both connector arms are properly in place, be sure to test the oven rack operation by gently closing the oven door. The oven rack should move in and out of the oven freely when the door is opened or closed.

CAUTION

Never pick up hot oven rack parts. Make sure the oven and oven racks are COMPLETLY cool and safe to touch before attempting to assemble or disassemble the Effortless™ Oven Rack.

IMPORTANT

REMOVE ALL OVEN RACKS and accessories before starting a self-clean cycle. If the oven racks are left in the oven during the self-clean cycle, the glide ability of the Effortless™ Oven Rack system will be damaged and will cause oven racks to loose their shiny finish. Remove ALL oven racks and clean according to instructions provided in the Care & Cleaning section of this manual.

IMPORTANT

•Only the Effortless™ Oven Rack system should be used in oven rack position 2. Placing ANY other rack in oven rack position 2 will prevent the oven door from fully closing and may damage the oven door, oven cavity or the door connector brackets.

•If the rack system is not assembled with the connector arms the Effortless™ Oven rack may be used in oven rack positions 2 thru 7. Do not attempt to use the Effortless™ Oven rack in rack position 1.

door

rack connector

bracket

connector

 

bracket

 

Fig. 2

Fig. 1

connector

oven

arm

rack

Fig. 3 - assembly of the Effortless™ Oven Rack

open oven

connector

door

arm

connector arm

Fig. 4

connector

arm

Fig. 5

left and right

door connector brackets

with connector arm ends shown in locked position (pointing upwards)

8

Fig. 6 - Effortless™ Oven Rack after assembly

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Use&Care Contents Product Record and RegistrationDefinitions Tip Over HazardImportant Instructions for Using Your Oven Important Safety Notice When flaming foods under a ventilating hood, turn the fan onBefore Setting Oven Controls Oven vent locationOven racks Oven rack stopTypes of oven racks Air circulation in the ovenBaking layer cakes with 1 or 2 oven racks Bottom oven rackEffortless Oven Rack system To assemble the Effortless Oven Rack systemBefore Setting Surface Controls Element on & hot surface indicator lightsAbout the ceramic glass cooktop About the radiant surface elementsUsing proper cookware Cookware material types for the cooktopSetting Surface Controls Suggested surface element settingsSingle radiant surface elements To operate a single radiant elementDual radiant surface elements some models To operate a dual radiant elementKeep warm zone some models Home canning National Center for Home Food Preservation NchfpRead the Instructions Carefully Before Using the Oven Oven Control FunctionsSetting Oven Controls Setting the clockChanging temperature display mode F or C Setting for audible or silent keypad operationSetting lock feature Setting the timerSetting bake To change the oven temperature after bake has startedBake time To set bakeWhen the set bake time runs out Start timeSuggestions for quick bake Setting quick bakeHow quick bake works Minimuminternalcookingtemperatures Easy probeProper probe placement in food Probe error messageEasy probe cont’d To set easy probeTo set broil Suggested broil settings tableBroil Operating the oven light Adjusting the oven temperatureTo adjust oven temperature Read before starting self-clean SELF-CLEANINGSelf-clean Setting clean To set self-cleanWhen the self-clean cycle ends Restarting self-clean after a power failureSetting self-clean with start time To set self-clean with delay start instructionsCare & Cleaning Cleaning recommendation tableTo maintain the cooktop appearance Cooktop maintenanceCooktop cleaning Cooktop cleaning cont’d Aluminum foil and oven linersAluminum foil and oven liners cont’d Replacing the oven lightTo replace oven door Removing and replacing the lift-off oven doorTo remove oven door Problem Possible Causes Solutions OvenControls sectionSolutions to common problems Before YOU Call Problem Possible Causes Solutions Bake or self-clean Under Self-cleaningProblem Possible Causes Solutions Major Appliance Warranty Disclaimer of Implied Warranties Limitation of Remedies
Top Page Image Contents