Lighting the Grill
BEFORE LIGHTING
Important! Before Lighting...
Check the gas supply line for cuts, wear or abrasion.
Always keep your face and body as far away from the grill as possible when lighting.
GRILL BURNER LIGHTING
Lighting the Grill with electronic igniter
1.Make sure all control knobs are in the “OFF” position.
2.Open the gas supply valve located on top of your L.P. tank.
ATTENTION: When turning the L.P. tank on, make sure to open the valve very SLOWLY two (2) complete turns to insure proper gas flow.
3.Always open the hood before attempting to light.
4.Push and turn one of the control knobs counter clock- wise to the “HIGH” position and immediately press the electronic igniter button. You will hear a snapping sound. It may be necessary to hold the electronic starter button for about 4 seconds. (See Fig. 15)
NOTE: If the burner does not light in 4 seconds, turn the knob to the “OFF” position and wait 5 minutes before trying again.
5. Repeat above steps to light remaining burners.
Match Lighting
If by chance the electronic igniter does not light the burner, the burner may be lit with a match. Attach the match to the match extender, located inside the right cart door.
Keep your face as far away from the grill surface as possible and pass the match extender through the spaces in the grill grates to the ports of the back crossover burner between the flavor grids. Position the match near the burner ports, then push and turn the control knob counter clockwise to the “HIGH” position. (See Fig.
NOTE: If the grill will not light after several attempts see the
Do not attempt to
“Light” the grill if the
odor of gas is present!!
Crossover Burner
Fig. 15
Fig. 16
Fig. 17
12