Frigidaire beverage cooler important safety instructions Sound and Noise, Cloudy Beer When beer

SOUND AND NOISE (Cont.)

Vibrating or rattling noise.	• Beverage cooler is touching the wall.	• Move beverage cooler slightly away from the wall.
Snapping sound.	• Cold control turning beverage cooler on and off.	• This is normal.

WATER / MOISTURE / FROST INSIDE BEVERAGE COOLER

Moisture forms on inside of	• Weather is hot and humid.	• This is normal.
beverage cooler walls.	• Door may not be seating properly.	• See “DOOR PROBLEMS” Section.
	• Door is kept open too long or opened too frequently.	• Open the door less often.

WATER / MOISTURE / FROST OUTSIDE BEVERAGE COOLER

Moisture forms on outside of beverage cooler walls.

•Door may not be seating properly, causing the cold air from inside the beverage cooler to meet warm moist air from outside.

•See “DOOR PROBLEMS” Section.

ODOR IN BEVERAGE COOLER

Odors in beverage cooler.

•Interior needs to be cleaned.

•Clean interior with sponge, warm water, and baking soda.

DOOR PROBLEMS

Door will not close.

•Beverage cooler is not level. It rocks on the floor when it is moved slightly.

•This condition can force the cabinet out of square and misalign the door. Level the unit.

COMMON DRAFT PROBLEMS

WILD BEER – Beer, when	• Beer drawn improperly.	• Make sure		faucet	is	opened all		the	way. Close
drawn, is all foam, or too		quickly when done.
much foam and not enough	• Creeping regulator.	• Replace regulator.
liquid beer.	• Applied pressure is set too high.	• Readjust regulator to a lower pressure until foam
		subsides. When pressure is properly set, you should
		be able to pour 10 oz. of beer in about 5 seconds.
	• Hot spots in line.	• Make sure beer delivery line is not pinched and is
		fully inside the interior of the beverage cooler.
	• Tapped into a warm keg (should be 34ºF ~ 38ºF).	• Wait until keg cools down to proper temperature.
	• Cooler malfunctioning.	• Have beverage cooler serviced to return it to proper
		operating condition.
	• Faucets in bad, dirty or worn condition.	• Thoroughly		clean	faucet		with	recommended
		cleaning kit. Replace any worn seals.
FLAT BEER – Foamy head	• Dirty glasses.	• Wash glasses using soap-free detergent.
disappears quickly; beer lacks	• Applied pressure is set too low.	• Increase pressure until beer flows at a rate of 2 oz.
usual zestful brewery fresh		per second.
flavor.	• CO2 is turned off.	• Do not turn off CO2 supply line to keg until keg is
		empty and ready to be removed.
	• Beer too cold.	• Increase	temperature			of	beverage		cooler	(see
		SETTING THE TEMPERATURE CONTROL).
	• Loose tap or vent connections.	• Check that coupler is properly installed in keg.
	• Sluggish regulator.	• Replace regulator.
CLOUDY BEER – When beer	• Frozen or nearly frozen beer.	• Return keg to place of purchase and exchange for
in glass appears hazy, not		one that has been properly refrigerated.
clear.	• Unrefrigerated beer for long periods of time.	• Exchange keg for fresh one.
	• Dirty glasses.	• Wash glasses using soap-free detergent.
	• Dirty faucet.	• Clean faucet with recommended cleaning kit.
	• Unrefrigerated foods placed on top of cold keg.	• Remove	items from			atop	keg and		place	in a
		separate refrigerator.

12