BEVERAGE DELIVERY KIT BOX |
| ||||||
(9) Faucet and Shank Assembly | 1 piece | ||||||
(10) | Plastic Collar | 1 piece | |||||
(11) | Shank Nut | 1 piece | |||||
(12) | Faucet Knob | 1 piece | |||||
(13) | Regulator | 1 piece | |||||
(14) | Keg Coupler | 1 piece | |||||
(15) | Clear Hose (Delivery Line) | 1 piece | |||||
(16) | Red Hose (Gas Line) | 1 piece | |||||
(17) | Rubber Washer (Black) | 2 pieces | |||||
(18) | Plastic Hose Clamp (White) | 2 pieces | |||||
(19) | CO2 Canister (Empty) | 1 piece | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(9) FAUCET & |
| (10) PLASTIC |
| (11) SHANK NUT |
| (12) FAUCET |
SHANK ASS’Y. |
| COLLAR |
|
|
| KNOB |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(13) REGULATOR | (14) KEG | (15) CLEAR HOSE | (16) RED HOSE | ||
|
| COUPLER | (DELIVERY LINE) | (GAS LINE) | |
|
|
|
|
|
|
|
|
|
|
|
|
INSTALLATION – GENERAL INSTRUCTIONS
•Choose a place that is near a grounded electrical outlet. DO NOT use an extension cord or an adapter plug.
•For the most efficient operation, the beverage cooler should be located where surrounding temperatures will not drop below 10ºF
•Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides of the beverage cooler for adequate air circulation.
(17) RUBBER
WASHER
(18) HOSE
CLAMP
LEVELING
(19)CO2 CANISTER
The beverage cooler must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded beverage cooler. NOTE: It is Very Important for your beverage cooler to be level in order to function properly. If the beverage cooler is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost, or moisture problems.
To Level Your Beverage Cooler:
Carefully tip the unit onto its back. Remove and discard the wood skid from the bottom using a 3/8” socket wrench. After discarding crating screws and wood skid, use a carpenter’s level to level the beverage cooler from front to back. Adjust the plastic leveling feet in front, ½ bubble higher, so that the door closes easily when left halfway open.
NOTE: The exterior walls of the beverage cooler may become quite warm as the compressor works to transfer heat from the inside. Temperatures as much as 30ºF warmer than the room temperature can be expected. For this reason it is particularly important in hotter climates to allow enough space for air circulation around your beverage cooler.
4