ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1.Visually inspect the cooktop for damage. Also make sure all cooktop screws are tight (see Figure 8).
Screws
Figure 8
2. Install the retainer brackets (See Figure 9).
The retainer brackets MUST be installed, to meet local codes or, in their absence, with the National Electrical Code ANSI/NFPA No.
Cooktop | Countertop | |
| Nylon | |
| spacer | |
|
| |
| Retainer | bracket |
|
| Figure 9 |
3. Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should be removable for service when needed.
WARNING Do not remove the nylon spacers on the edges of the cooktop. These spacers center the cooktop in the space provided. The cooktop must be centered to prevent excess heat buildup that may result in heat damage or fire (see Figure 10).
6 Nylon spacers
C L
Position brackets
on unit cutout
center line2 Retainer brackets
Figure 10
Checking Operation
Refer to the Use and Care Guide for operation.
CAUTION Do not touch cooktop glass or elements. They may be hot enough to burn you.
Model and Serial Number Location
The serial plate is located under the cooktop.
When ordering parts for or making inquires about your cooktop, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your cooktop.
Before You Call for Service
Read the Before You Call for Service Checklist and operating instructions in your Use and Care Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.
5