Electro-Voice P3000RL owner manual Specifications / Technische Daten, DIM30

SPECIFICATIONS / TECHNISCHE DATEN

-System (amplifier) at rated conditions, both channels driven, 8Ω loads, unless otherwise specified.

-Depending on the ambient temperature, the unit might not operate continuously at 2Ω load.

Load Impedance	8Ω		4Ω	2Ω
Maximum Midband Output Power	2x		2x	2x
THD = 1%, 1kHz	850W		1300W	1800W
Rated Output Power	2x		2x	2x
THD < 0.2%, 20Hz ... 20kHz	750W		1200W	1700W
Max. Single Channel Output Power	950W		1700W	2000W
Dynamic-Headroom, IHF-A
Maximum Bridged Output Power	2800W		3600W	-
THD = 1%, 1kHz
Maximum RMS Voltage Swing			91V
THD = 1%, 1kHz
Power Consumption			1850W
at 1/8 maximum output power @ 4Ω
THD at rated output power,		< 0.05%
MBW = 80kHz, 1kHz
IMD-SMPTE		< 0.05%
60Hz, 7kHz
DIM30		< 0.05%
3.15kHz, 15kHz
Crosstalk Attenuation			> 70dB
ref. 1kHz, at rated output power
Frequency Response			20Hz ... 20kHz
-0.5dB, ref. 1kHz
Damping Factor		> 300
1kHz
Signal to Noise Ratio, Amplifier			109dB
A-weighted
Signal to Noise Ratio, System			100dB
A-weighted
Input Sensitivity		+6dBu (factory configured)
at rated output power @ 8Ω, 1kHz			0dBu
internal selectable			26dB constant gain
Max. Input Voltage			+21dBu (8.7V)
Input Impedance			20kΩ
20Hz ... 20kHz, balanced
CMR			80dB
1kHz
Output Voltage			rated: +6dBu (1.55V)
DSP OUT / Monitor			max: +21dBu (8.7V)
Output Impedance			< 100Ω
DSP OUT / Monitor
Minimum Output Load			600Ω
DSP OUT / Monitor
	Digital Signal Processing
AD & DA Conversion	24 Bit, Sigma-Delta, 128 x Oversampling, Linear Phase
Sample Rate			48kHz
Internal Wordlength			48 bit
Dynamic Range			115dB (typical)

32