Electrolux EGG 689 manual Ignition System / Gas Ignition

Page 12

Ignition System / Gas Ignition

Ignitor does not spark

Check gas supply at burner

Check plug top fuse and replace if necessary

Check polarity and earth continuity of supply point

Check earth continuity of appliance

Check continuity from 'N' on the mains connector block and "O" on the ignitor unit

Check continuity from 'L' on the mains connector block and the taps ignition switches

Check continuity from the tip of each electrode to the terminals 1 to 4 on the ignitor unit

Check for breaks in the insulation of the HT leads

Light burner manually

Check by pass simmer adjusted

Check position of the electrode

Check fitting of burners



Check continuity from ignition					Change the taps
switches connector to ignitor unit					ignition switches

Change the ignitor unit

Image 12

Contents Instruction Booklet Important Safety Information Contents Description of the HobMaintenance and Cleaning OperationService and Spare Parts Symptom SolutionSomething Not Working? Guarantee Conditions Customer Care DepartmentInstructions for the Installer Engineers technical dataSupply connections Appliance Class Appliance Category II2H3+Important safety requirements InstallationWhen the HOB is First Installed LocationBuilding Cut Out SizeBuilding over a cupboard or drawer Building over a kitchen unit with doorSupply cable replacement Electrical connectionsPermanent Connection This Appliance Must be EarthedWiring Diagram Fault FindingPreliminary Electrical Systems CheckIgnition System / Gas Ignition Minimum adjustment screw CommissioningTo adjust the gas rate Conversion from Natural Gas toPage Customer Care