Electrolux EGG 689 manual Cut Out Size, Building over a cupboard or drawer

Page 9

Cut Out Size

The dimensions of the cut-out are given in the diagram.

30

550

FO 2098

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.

Building over a kitchen unit with door

Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge (diagram 4) of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.

Φ1) Remove the pan supports, the burners caps and crowns and turn the hob upside down, taking care the ignition candles are not damaged in this operation.

2)Place the sealing gasket all around the glass top edge as shown in diagram 4.

3)Fit the hob in the cut out and push it down until the glass top and the working top make contact, as shown in diagram 5.

 

 

 

1

 

 

ON/OFF SWITCH

 

 

FLEX

 

 

 

OUTLET

 

 

 

FO 0763

 

 

ON/OFF SWITCH

2

 

3

 

 

 

30

 

 

a

min

 

60

20

 

 

FLEX

 

b

 

 

 

 

OUTLET

 

 

 

FO 0764

FO 1013

 

 

Dimensions are given in mm.

FO 2108

4

FO 2107

5

 

 

A

a) Sealing gasket

9

 

Image 9
Contents Instruction Booklet Important Safety Information Description of the Hob ContentsOperation Maintenance and CleaningService and Spare Parts Symptom SolutionSomething Not Working? Customer Care Department Guarantee ConditionsEngineers technical data Instructions for the InstallerSupply connections Appliance Class Appliance Category II2H3+Installation Important safety requirementsWhen the HOB is First Installed LocationCut Out Size BuildingBuilding over a cupboard or drawer Building over a kitchen unit with doorElectrical connections Supply cable replacementPermanent Connection This Appliance Must be EarthedFault Finding Wiring DiagramPreliminary Electrical Systems CheckIgnition System / Gas Ignition Commissioning Minimum adjustment screwConversion from Natural Gas to To adjust the gas ratePage Customer Care