Electrolux 3531 WK-M manual Safety information, Installing, During Use, Child Safety

Page 4

Safety information

These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance.

Installing

Do not install the hob if the ceramic glass is damaged or cracked.

This gas hob must be installed according to the instructions supplied. Any installation work must be undertaken by a authorised competent person.

Do not alter the specifications or attempt to modify the appliance in any way.

During Use

The gas hob is intended for domestic cooking only. It is not designed for commercial/industrial purposes.

Ensure that all the control knobs are in the OFF position when not in use.

Do not use the gas hob if it is damaged in any way, contact your local AEG Service Centre;

1 Stamford Road Oakleigh Victoria 3166 Telephone 1300 650020

Never use plastic or aluminium dishes on the gas hob.

Never leave the gas hob unattended while deep fat frying, or heating fats and oils.

Do not use or store flammable materials near this appliance. Do not spray aerosols in the vicinity of this appliance while it is in operation. Where this appliance is installed in marine craft or caravans, it shall not be used as a space heater

The appliance is not intended for use by young children or infirm persons without supervision.

Child Safety

Young children should be supervised to ensure that they do not play with the appliance

The gas hob gets hot when it is in use. Children should be kept away until the gas hob has cooled.

Maintenance and Cleaning

Only clean this gas hob in accordance with the instructions given in this book.

4

Image 4
Contents WK-m Page Table of contents Safety information InstallingChild Safety Maintenance and CleaningService ServiceDisposal Primary air intake apertureDescription of the product Technical data Before leaving Units externally measured lengthBurner cover/burner ring Use of Hose Assemblies Gas installation IgnitionsCut-out measurements Mounting of Reinforcement BeamsCleaning of gas burner Stainless steel surfacesCare must be taken to avoid boil-over Data label