Burner cover/burner ring

Together with the burner ring the burner

cover forms a space where the final	Burner ring	Burner cover
mixture of gas and air takes place in		Correct
order to make the gas burn correctly.

Please note: It is consequently very important that the burner cover/ring is placed correctly on the burner. The

burner ring has been provided withWrong holes for the ignition electrode, and the

thermo sensor.

If the burner cover/ring are wrongly placed the burner will operate incorrectly, and the burners may be damaged within at short space of time.

Electrical Connection

This appliance is supplied with an 1800mm long flexible supply lead and 3 pin plug. The point of connection is located at the rear and on the underside of the appliance. Connect the appliance to a readily accessible switched general purpose outlet which is adjacent to the appliance.

THIS APPLIANCE MUST BE CONNECTED TO AN EARTHED GENERAL PURPOSE OUTLET.

Ignition electrode (A)

The burner has been provided with an ignition electrode. As long as the operating knob is depressed, the automatic ignition will ensure that a spark is emitted between the ignition electrode and the burner cover.

Thermo Sensor (B)

The hob unit features fully-secured gas taps (thermo-fuse)

In case the flame goes out, the thermo sensor automatically prevents gas admission after a few seconds (max. 90 seconds).

Note: Gas admission is always allowed while the operation button is pressed - See start-up procedure

Burner	Main nozzle
Burner ring	Burner cap

Ignition electrode (A)

T hermo Sensor (B)