PREPARE THE HOOD
1.Unpack hood and check contents. You should receive: 1
1
1 - Ductree filter (F24WR and F30WR hoods only)
2.Remove wiring box cover. Under cover find:
1
3.Remove top or rear electrical knockout. (FIG. 2)
4.(F30WV hood ONLY) Remove duct knockout. Insert screw- driver under edge of knockout, break tabs, and peel knock- out back with pliers. (FIG. 3)
5.(F30WV hood ONLY) Install damper/duct connector over opening made in STEP 4. Use #8B sheet metal screws pro- vided. (FIG. 3)
PREPARE THE INSTALLATION LOCATION
Omit STEP 1 if hood will be installed under cabinets with flush bottom.
1.(For installation on recessed bottom cabinets only) Attach a wood filler strip at each side of recessed area under cabi- net. Use two 1" x 2" strips cut to length. If recess is deeper than 1" use thicker strips. Attach strips with
2.Measure and mark the following (FIGS. 5A & 5B): a.) Electrical wiring opening in wall or cabinet.
b.) Duct opening in wall or cabinet (F30WV hood ONLY).
WARNING
WHEN CUTTING OR DRILLING INTO WALL OR CABINET, BE CAREFUL NOT TO CUT EXISTING ELECTRICAL WIRING.
3.Use
4.Cut out duct opening in wall or cabinet with saber saw or keyhole saw.
5.Center hood in installation opening and trace keyhole slots onto wood filler strips on cabinet bottom.
6.Screw four #10 x 7/8 wood screws into exact center of narrow end of traced keyhole slots. Allow 3/8" of screws to project, so that hood can be fitted into place later.
FIG. 1 |
| |
| WIRING BOX COVER | |
DUCTFREE |
| |
FILTER | KEYHOLE | |
(F24WR & | ||
SLOTS | ||
F30WR | ||
| ||
HOOD |
| |
ONLY) |
| |
ALUMINUM |
| |
FILTER |
| |
(F30WV |
| |
HOOD |
| |
ONLY) |
| |
DAMPER/DUCT CONNECTOR (F30WV HOOD ONLY) | ||
FIG. 2 |
| |
FIG. 3 |
| |
ELECTRICAL |
| |
KNOCKOUTS |
| |
| HINGE | |
| PINS | |
| DUCT | |
| KNOCKOUTS | |
FIG. 4 |
| |
3