Frigidaire 318203821E warranty Models with Ceramic Glass Cooktop, About the Ceramic Glass Cooktop

Setting Surface Controls

Models with Ceramic Glass Cooktop

Model A Model B

	Model C				Model D
	Cooktop radiant areas that heat
	Your appliance may have one of these
		configurations - Figure 1
OFF		OFF			OFF		Small	OFF		Large
							Petit			Grand
lo	hi	lo	hi	lo	hi		hi			hi
sim		sim		sim
2	8	2	8	2		8	6			6
3	7	3	7	3		7	4			4
							2.		. 2
4	6	4	6	4	6		.			.
							... ...
							.		.
med		med			med		lo		lo

Model B shown Only - Figure 2

NOTE: Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning section and Before You Call checklist section of this Use and Care Guide.

NOTE: Radiant elements have a limiter that allows the element to cycle on and off, even at the HI setting. This helps to prevent damage to the ceramic smooth top. Cycling at the HI setting is normal and can occur if the cookware is too small for the radiant element or if the cookware bottom is not flat (Refer to page 12 under Selecting Surface Cooking Utensils).

About the Ceramic Glass Cooktop

The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element outline on the cooktop (See Figure 1). Heat is transferred up through the surface of the cooktop to the cookware. Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and their settings, are all factors that will affect the amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns.

About the Radiant Surface Elements

The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and consistent heat during the off cycle. For efficient cooking, turn off the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.

Locations of the Radiant Surface Elements and Controls

Your range is equipped with radiant surface elements with different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases.

The radiant surface elements are located on the cooktop as follows:

Model A (See Figure 1):

-Two dual 5 or 7 inch radiant element at the right and left rear position;

-Two dual 6 or 9 inch radiant element at the right and left front position;

Model B (see Figures 1 and 2) and Model C (Figure 1):

-One 6 inch radiant element at the right rear position;

-One 6 or one 8 inch radiant element at the left rear position (varies with models);

-A dual 6 or 9 inch radiant element at the right front position;

-A 6 or one 9 inch radiant element located at the left front position (varies with models);

Model D (Figure 1):

-A 6 inch radiant element at the right rear position;

-A dual 6 or 9 inch radiant element at the right front position;

-Two 8 inch radiant elements located at both the left front and rear positions.

-Between left front and rear elements is a Bridge radiant element. The BRIDGE radiant element is controlled using the same knob that controls the left front radiant element position.

NOTE: Due to the high intensity of heat generated by the surface elements, the glass surface will turn green when the element will be turned off. This phenomenon is normal and the glass will come back to its original white color after it has completely cooled down. (White glass cooktops only).

8