Frigidaire 318200869 manual Before Setting Warmer Drawer Controls some models

Before Setting Warmer Drawer Controls (some models)

Arranging Warmer Drawer Rack Positions

Set the warmer drawer rack in the vertical position as shown below:

The rack can be used in 2 ways:

•In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish under).

•In the Downward position to allow you to place light weight food items and empty dishware (for example, rolls or pastries and din- ner plates).

Upright Position

Downward Position

Setting Warmer Drawer Controls (some models)

Note: The warmer drawer cannot be used during an oven self-cleaning cycle. The warmer drawer is equipped with a catch which may require extra force when opening and closing the drawer.

Use the warmer drawer to keep hot foods hot such as: vegetables, gravies, meats, casseroles, biscuits and rolls, pastries and heated dinner plates.

To Operate the Warmer Drawer

The purpose of the warmer drawer is to keep hot cooked foods at serving temperature. Always start with hot food. It is not recommended to heat cold food in the warmer drawer.

All food placed in the warmer drawer should be covered with a lid or aluminum foil to maintain moisture and softness. Do not cover crisp foods. Do not use plastic wrap to cover food. Plastic may melt onto the drawer and be very difficult to clean. Use only dishware, utensils and cookware recommended for oven use in the warmer drawer.

Always use potholders or oven mitts when removing food from the warmer drawer as cookware and plates will be hot.

To Set the Warmer Drawer Controls:

The control and indicator lights for the Warmer Drawer features are located on the control panel. The temperatures are approximate, and are designated by HI (high), MED (medium) and LO (low).

1.Touch the ON/OFF pad at the Warmer Drawer control position. The Warmer Drawer indicator light will flash. Note: If no further pads are touched within 25 seconds the request to power the Warmer Drawer ON will clear.

2.Set the desired power level. Touch UP ARROW once to turn ON the power level for HI (see Figure 2) or DOWN ARROW to turn ON the power level for LO (see Figure 4). The Warmer Drawer indicator light located beside the ON/OFF pad will turn ON steady.

3.Each touch of the DOWN ARROW or UP ARROW pads will decrease or increase through 6 power levels from HI (see Figure 2) to MED (see Figure 3) to LO (see Figure 4). Note: For best results, preheat the Warmer Drawer before adding the food . An empty drawer will preheat in approximately 15 minutes.

4.When the food is ready for removal, touch the ON/OFF pad once to turn the Warmer Drawer OFF. The Warmer Drawer indicator light will turn OFF.

Figure 1

Figure 2

Figure 3

Figure 4

9