Frigidaire 316902304 Setting Surface Controls, Single radiant surface elements all models

Page 11

Single radiant surface elements (all models)

To operate the single radiant element:

1.Place correctly sized cookware on single radiant surface element.

2.Push in and turn the surface control knob in either direction (Fig. 2) to the desired setting (Refer to the

Suggested radiant surface element settings table Fig. 1). Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. The surface control knobs do not have to be set exactly on a particular spot. Use the graphics provided as a guide and adjust the control knob as needed (See Fig. 2). Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

3.When cooking is complete, turn the radiant surface element OFF before removing the cookware.

Suggested radiant surface element settings

The suggested settings found in Fig.1 below are based when cooking with medium-weight aluminum pans with lids. Settings may vary when using other types of pans.

Suggested settings for single and dual radiant elements table (use with Fig. 3)

Settings

Type of cooking

 

 

High (HI - 9)

Start most foods, bring water to a

 

boil, pan broiling

 

 

Medium high (7 - 8)

Continue a rapid boil, fry, deep fat fry

 

 

Medium (5 - 6)

Maintain a slow boil, thicken sauces

 

and gravies or

 

steam vegetables

 

 

Medium Low (2 - 4)

Keep foods cooking, poach, stew

 

 

Low (LO - 1)

Keep warm, melt, simmer

 

 

 

Fig. 1

SETTING SURFACE CONTROLS

Fig. 2

CAUTION

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

IMPORTANT

Do not allow aluminum foil, or ANY material that can melttomakecontactwiththeceramicglasscooktop. If these items melt on the cooktop they will damage the ceramic cooktop.

NOTES

The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.

The Element ON indicator lights will glow when one or more elements are turned ON. A quick glance at these indicator lights when cooking is finished is an easy check to be sure all control knobs are turned OFF. The Hot Surface indicator light will continue to glow AFTER the control knob is turned to the “OFF” position and will glow until the heating surface area has cooled sufficiently.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Use&Care Product Record and Registration ContentsDefinitions Important Safety InstructionsImportant Instructions for Using Your Oven SELF-CLEANING Ovens Your electric range features include Features AT a GlanceRemoving, replacing & arranging racks Before Setting Oven ControlsOven vent location Types of oven racksSpecial dark coating on the left and right rack Effortless Oven Rack systemTo assemble the Effortless Oven Rack system About the ceramic glass cooktop Element on & hot surface indicator lightsAir circulation in the oven Baking layer cakes with 1 or 2 oven racksCookware material types Before Setting Surface ControlsUsing proper cookware Types of cooktop elementsTo operate the single radiant element Setting Surface ControlsSuggested radiant surface element settings Single radiant surface elements all modelsTo operate a dual radiant element Quick boil feature some modelsMed Home Canning Oven Control Functions Minimum & maximum control settingsFeature Min. temp. /time Max. temp. /time Changing oven temperature display Setting Oven ControlsSetting the clock Setting 12 or 24 hour display modesAdd a minute feature Setting a silent control panelSetting oven lockout Setting the minute timerWhen the set bake time runs out Setting quick preheatSetting bake Setting bake timeSetting Oven Controls Press convect Benefits of the convect featureConvect roast all models Suggestions for convect bakingSuggestions for convect broil Setting convect convection convertConvect broil some models Leave the oven door open Suggested broil settings table electric ovenBroil To set broil Step PressSetting keep warm Setting pizza featureSetting chicken nuggets feature Setting chicken nuggets feature cont’dOperating the oven light Adjusting the oven temperatureExample increase the oven temperature by 30F Step Press Example decrease the oven temperature by 30F Step PressBake time and delay start pads To Set the Sabbath Feature for use onIf a timed bake or delayed timed bake is needed To Set the Sabbath Feature cont’d Adhere to the following self-clean precautions SELF-CLEANINGSelf-cleaning When the self-clean cycle has completed Press delay startCleaning recommendation table Care & CleaningFor heavy, burned on soil Cooktop maintenance Cooktop cleaningDo not For light to moderate soilTo replace the oven light bulb Cooktop cleaning cont’dReplacing the oven light To replace oven door Removing and replacing the lift-off oven doorTo remove oven door Problem Solution Cleaningsection Used. See Cooktop Cleaning and Maintenance in the CareDisclaimer of Implied Warranties Limitation of Remedies Major Appliance Warranty

316902304 specifications

The Frigidaire 316902304 is a high-quality oven burner assembly that serves as a crucial component in the operation of various Frigidaire cooktops and ranges. Designed with efficiency and reliability in mind, this burner assembly ensures an even and consistent heating experience, making it easier to prepare meals to perfection.

One of the main features of the Frigidaire 316902304 is its construction from durable materials designed to withstand the rigors of daily cooking. This high-grade metal not only contributes to the longevity of the product but also supports optimal heat distribution across the cooking surface, allowing for even cooking results. The design facilitates easy installation, enabling users to replace worn-out or damaged burners effortlessly, ensuring minimal downtime in the kitchen.

Incorporating advanced technologies, the Frigidaire 316902304 utilizes modern engineering techniques that enhance cooking performance. It boasts efficient energy consumption, reducing overall cooking times and energy bills. This oven burner assembly features compatibility with various types of fuel, including natural gas and propane, which gives consumers the flexibility to choose the best option for their cooking needs.

Another significant advantage of this burner assembly is its compatibility with a wide range of Frigidaire models. This versatility makes it an ideal choice for homeowners, professional chefs, or anyone needing a reliable burner to enhance their cooking experience. The burner is designed to fit seamlessly into a range of Frigidaire appliances, making it easy to upgrade or replace.

In terms of safety features, the Frigidaire 316902304 has built-in mechanisms to prevent flame blowout, ensuring a safe cooking environment. This aspect is particularly important for families with children and pets, as it minimizes the risk of accidents in the kitchen.

The Frigidaire 316902304 is also designed for easy cleaning, with a smooth surface that allows for quick wipe-downs and maintenance. With its robust design, energy efficiency, compatibility, and safety features, the Frigidaire 316902304 is an essential component for anyone looking to enhance their cooking experience while ensuring durability and performance in their kitchen.
Top Page Image Contents