Frigidaire 318205852 manual Occurrence Possible CAUSE/SOLUTION

Page 34

before you call (Solutions to Common Problems)

IMPORTANT

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

 

 

Range is not level.

Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust

 

leveling legs at base of range until the rack is level. When range is level, cooktop may

 

appear out of alignment if countertop is not level.

 

Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is

 

sagging or slopping, contact a carpenter to correct the situation.

 

Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are

 

square and have sufficient room for range clearance.

Cannot move

Cabinets not square or are built in too tight. Contact a cabinet maker to correct the

appliance easily.

problem.

Appliance must

 

Contact builder or installer to make appliance accessible.

be accessible for

 

service.

Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.

 

 

 

Gas line is hard-plumbed. Have a flexible C.S.A international approved metal appliance

 

connector installed.

Entire range or oven

Make sure cord/plug is plugged tightly into outlet.

does not operate.

 

Service wiring is not complete. Call an authorized servicer.

 

 

 

 

Electrical power outage. Check house lights to be sure. Call your local electric company for

 

service. Surface burners can be lit manually.

Oven control beeps

Electronic control has detected a fault condition. Press Cancel to clear the display and stop

and displays any F

beeping. Reprogram oven. If fault recurs, record fault number. Press Cancel and call an

code error (ex.: F11)

authorized servicer for assistance.

Oven light does not

Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide. (2)

work.

Electrical power outage. Check house lights to be sure. Call your local electric company for

 

service.

Surface burners do

Surface control knob has not been completely turned to LITE. Push in and turn the surface

not light.

control knob to LITE until burner ignites and then turn the surface control knob to the

 

desired flame size.

 

Burner ports are clogged. Clean burners. See “Cleaning the Burner Grates, Burner Caps

 

and Burner Heads” under General Cleaning.

 

Range power is disconnected from outlet. Be sure cord is securely plugged into the outlet.

 

 

 

Electrical power outage.

 

 

 

Be sure the gas supply to the range is turned “ON”.

 

 

Surface burner

Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to

flame burns half way

clean ports or slots.

around.

 

Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate

 

 

until flame is full. Dry the burners thoroughly following instructions under General Cleaning.

 

 

Surface burner flame

Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.

is orange.

 

Salt air in coastal areas. A slightly orange flame is unavoidable.

 

 

 

Poor baking results.

Many factors affect baking results. Make sure the proper rack position is used. Center

 

food in the oven and space pans to allow air to circulate. Allow the oven to preheat to the

 

set temperature before placing food in the oven. Try adjusting the recipes’ recommended

 

temperature or baking time. If you feel the oven is too hot or cool, see “Adjusting Your

 

Oven Temperature” section in the Electronic Oven Control Guide.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Use &Care Product Welcome & CongratulationsRegister Your Product Please Carefully read and save these instructionsDefinitions Important Safety InstructionsFor Your Safety What to do if YOU Smell GASImportant Instructions for Using Your cooktop Know which knob controls each surface burnerImportant Safety Instructions for Using Your Oven Important Safety Instructions for Cleaning Your OvenConversion to liquefied petroleum gas or L.P. gas Grounding instructionsYour gas built-in range Features 09-025-FControl locations of the gas surface burners Before setting surface burnersAssembly of the surface burner caps and burner grates Remember do not Allow SPILLS, FoodOperating the gas surface controls Setting surface burnersSetting proper surface burner flame size Flame Size Type of CookingAir circulation in the oven Oven vent locationArranging oven racks Recommended rack PositionsTypes of oven racks Effortless oven rack system To assemble the Effortless Oven Rack systemControl pad features Setting Oven controlsTemperature Visual Display Feature Minimum TEMP. /TIME Maximum TEMP. /TIME Minimum and Maximum Control Pad SettingsSetting the Clock Changing between 12 or 24 hour time of day displaySetting Temperature Display Fahrenheit or Celsius Setting Continuous Bake or 6 Hour Energy SavingSetting Silent Control Operation Setting +1 Minute Feature Setting Minute TimerSetting Oven Lockout Feature To set the Preheat temperature for 375F Setting Power PreheatSetting Bake To set the Bake Temperature to 375FConvection Baking Tips Setting Convection BakeTo set the oven for Convection Bake and temperature to 375F Benefits of Convection BakeTo set a Convection Roast Temperature of 375F Setting Convection CONVERsionSetting Convection Roast Convection Roasting TipsWhen the timed bake finishes Setting Bake TimeSetting Delay Start Press Delay StartSetting Pizza Setting Keep WarmCancel Setting Chicken Nuggets Setting FavoriteOven Broiling Table Recommendations Setting BroilBroiling Tips To set a Broil of 500FSetting Oven Controls To adjust the oven temperature lower Adjusting Oven TemperatureTo adjust the oven temperature higher Oven lightAdhere to the following cleaning precautions Self-cleaningWhat to Expect during Cleaning When the Self-Clean Cycle is Completed Setting SELF-CLEAN Cycle Time LengthStopping or Interrupting a Self-Cleaning Cycle Keep warm drawer rack positions Setting keep warm drawer controlKeep warm drawer temperature selection Operating the keep warm drawerCare & Cleaning Cleaning Chart Cleaning various parts of your applianceCleaning the cooktop, burner caps & grates Care & CleaningCare and cleaning of stainless steel Changing oven light Removing and replacing the lift-off oven doorBe Sure Oven is Cool Push down latch with finger To remove and replace keep warm drawerTo Replace Keep Warmer Drawer Pull up latch with finger Right GlideOven baking Occurrence Possible CAUSE/SOLUTION Fan noise during Self-cleaning cycleSoil not completely removed after self- cleaning cycle Cooking operationExclusions This warranty does not cover the following Disclaimer of Implies Warranties Limitation of Remedies

318205852 specifications

The Frigidaire 318205852 is a high-quality oven igniter that has become a favored choice for many homeowners and professional chefs alike. This essential component plays a crucial role in the ignition process of gas ovens, ensuring that the appliance operates efficiently and safely. The reliability of the 318205852 makes it a great replacement part for those in need.

One of the standout features of the Frigidaire 318205852 is its impeccable build quality. Made from durable materials, it is designed to withstand high temperatures and the rigors of frequent use. This robustness ensures that it has a long service life, reducing the need for frequent replacements and saving on maintenance costs in the long run.

The igniter utilizes advanced technology to provide consistent and efficient performance. It has a rated voltage of 120 volts and works seamlessly within the gas oven system. This compatibility ensures that it can be easily integrated into a variety of Frigidaire models, making it a versatile choice for many users.

An important characteristic of the Frigidaire 318205852 is its ease of installation. Even those who may not be professionally trained can install the igniter with a bit of guidance. Clear instructions accompany the product, and the igniter is designed for a straightforward replacement process. This user-friendly feature minimizes downtimes for those who rely on their ovens.

In terms of safety, the Frigidaire 318205852 meets rigorous standards for quality and reliability. It is engineered to prevent potential fire hazards that can arise from faulty ignition systems. This focus on safety ensures peace of mind for users, knowing they are operating a dependable appliance.

Furthermore, the performance of the Frigidaire 318205852 contributes to improved energy efficiency, which is increasingly important for environmentally-conscious consumers. By providing reliable ignition, it helps to ensure that gas consumption is optimized, leading to lower energy bills and a reduced carbon footprint.

In conclusion, the Frigidaire 318205852 igniter is a critical component that stands out for its durability, ease of installation, and safety features. For anyone in need of a reliable igniter for their gas oven, this model is an excellent choice that offers peace of mind, efficient operation, and long-lasting performance.
Top Page Image Contents