General Cleaning
The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.
Changing Cooktop and/or Oven Lights
(if equipped)
To Remove and Replace Oven Door
To Remove Oven Door:
1.Open the door.
2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)
3.Close the door to the
4.To clean oven door, follow the instructions provided in the cleaning chart under General Cleaning
To Replace Oven Door:
1.Be sure the hinge arms are in the
2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.
3.Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the bottom corners of the door as far as they can go.
4.If the door is not in line with the oven frame, remove it and repeat the above steps.
Be sure the range is unplugged and all parts are COOL before replacing the surface or oven lights. Wear a
To Change the Cooktop Light (some models)
1.Turn power off at the main source or unplug the range.
2.Remove Phillips® Head screws (2) that secure the light cover and then lift the light cover off.
3.Remove bulb by rolling back and up. Install the new bulb by sliding down and rolling forward into place.
4.
To Change the Oven Light (some Self Cleaning Models)
On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1.Turn electrical power off at the main source or unplug the range.
2.Press wire holder to one side to release the glass shield.
3.Replace bulb with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder into place.
5.Turn power back on again at the main source (or plug the range back in).
6.The clock(if equipped) will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Owner's Guide.
16