Sherwood RD-7106 manual When CD, Video 1~VIDEO 4 is selected as an input source

ENGLISH

When CD, VIDEO 1~VIDEO 4 is selected as an input source

4	Select the digital or the analog input
	connected as desired.
	DIGITAL

INPUTS

Each time this button is pressed, the corresponding input is selected as follows;

o(ptical) 1	o(ptical) 2
A(nalog)	c(oaxial) 2	c(oaxial) 1

To listen to DTS or Dolby Digital program source in the 2-CH downmix mode(the stereo mode), the corresponding digital input should be selected. (For details, refer to “Downmixing into 2 front channels” on page 19.)

Notes:

When the selected optical or coaxial digital input is not connected, the selected DIGITAL INPUT indicator flickers meaning no sound. (Refer to “ENJOYING SURROUND SOUND” on page 16.)

The sound from the component connected to the selected digital input can be heard regardless of the selected input source.

Operate the selected component for

5 playback.

To play back the program sources in surround sound, refer to “ENJOYING SURROUND SOUND” on page 16.

Adjust the(overall) volume.

6

MASTER VOLUME

or

MASTER

DOWNUP

Adjusting the tone (bass and treble)

Enter the tone mode.

7 TONE MODE

“TONE ON” or “TONE OFF” is shown for 5 seconds.

Select the tone mode as desired.

8 ADJUST

Each time this button is pressed, the tone mode changes as follows:

TONE OFF: When listening to a pure program source

without the tone effect. TONE ON: When adjusting the tone for your taste.

When “TONE OFF” is selected.

The tone direct function is activated and the sound that bypasses the tone circuitry will be heard.

To cancel the tone direct function, select “TONE ON” performing the above steps 7 and 8.

When “TONE ON” is selected.

1) Select the tone mode as desired.

TONE MODE

Each time this button is pressed, the mode changes as follows;

BASS TRBL(treble) TONE ON

2)At the desired tone, adjust as desired.

ADJUST

In general, we recommend the bass and the treble to be set to 0(flat) level.

To complete tone adjustment, repeat the above steps

1)and 2). Notes:

If the tone display disappears, start from the step 7 again.

Extreme settings of the tone controls at high volume may damage your speakers.

In DTS or Dolby Digital mode, the tone controls cannot be adjusted and the tone direct function is activated automatically.

12