Change Basic Volume Settings
Note: All volume settings should be adjusted during normal or peak business hours. Adjusting them during slow times will likely produce volume settings that are too low.
Note: Inbound and outbound are always defined from the perspective of the headset.
Inbound Microphone Volume
Changing the inbound microphone volume affects the sound volume coming from the customer order point microphone. To turn up or down the inbound microphone:
1.Enter the configuration mode.
2.Select a new value for > The range is 0 (silent) to 20 (maximum).
Outbound Talk Volume
Changing the outbound talk volume affects the volume of the speaker at the customer order point.
Note: To avoid feedback, set the outbound talk volume as low as possible.
To change the outbound talk volume:
1.Enter the configuration mode.
2.Select a new value for > The range is 0 (silent) to 20 (maximum).
Vehicle Alert Volume
Changing the vehicle alert volume affects the volume of the vehicle alert signal on the headsets. To change the vehicle alert volume:
1.Enter the configuration mode.
2.Select a new value for > The range is 0 (silent) to 20 (maximum).
Outbound Greeter Message Volume
Changing the outbound greeter message volume affects the sound volume of the custom greeting messages and the system internal greetings (“Store Closed” and “Please Pull Ahead”). To turn up or down the greeter message volume:
1.Enter the configuration mode.
2.Select a new value for > The range is 0 (silent) to 20 (maximum).
Change the Monitor Volume
The monitor is an additional speaker that can be used to monitor
Inbound Listen
Changing the inbound listen volume affects how loudly the monitor plays the inbound (customer order point) communication. You can also disable the monitor playing inbound sounds. To change the inbound listen monitoring settings:
1.Enter the configuration mode.
2.Select
3.To enable or disable the monitor playing the inbound sounds, change the value for to or
4.To change the volume level, select a new value for The range is 0 (silent) to 20 (maximum).
Night Volume
You can assign a standard reduction in the volume level of the customer order point speaker for night hours when lower volume is typically required. With the night volume set, the system automatically adjusts the volume during night hours, then back to normal during the day. To change the night volume setting:
1. Enter the configuration mode. |
|
|
| |
2. Select a new value for |
| > |
| The range is |
|
| |||
0 (silent) to the current | day volume level |
| (maximum). |
|
Note: Night Volume is never higher than Day Volume. Night volume reduction is a subtracted value, not the resulting level; therefore, if it is the same as the day volume level, the speaker will turn off at night. You cannot change the day outbound talk volume on this screen, only the reduction amount identified above.
6