GE P2B918 installation instructions Using the clock and timer

Page 16

Instructions

Using the clock and timer.

Not all features are on all models.

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Touch the Clock pad.

Touch the number pads.

If number pads are not touched within one minute after you touch the Clock pad, the display reverts to the original setting. If this happens, touch the Clock pad and reenter the time of day.

Touch the Start pad until the time

of day shows in the display. This enters the time and starts the clock.

Instructions

Touch the number pads the same way you read them. For example, to set 12:34, touch the number pads 1, 2, 3 and 4 in that order.

To check the time of day when the display is showing other information, simply touch the Clock pad. The time of day shows until another pad is touched.

Operating

Installation

Instructions

 

 

Tips

The timer is a minute timer only.

The Clear/Off pad does not affect the timer.

To Set the Timer

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

Touch the Kitchen Timer On/Off pad.

Touch the number pads until the amount of time you want shows in the display. The maximum number of minutes that can be entered is 59. To set additional time, you will need to set it by hours and minutes.

For example, to enter 1 hour and 30 minutes, touch 1, 3 and 0 in that order.

If you make a mistake, press the Kitchen Timer On/Off pad and begin again.

Touch the Start pad. After pressing the Start pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the Kitchen Timer On/Off pad is touched.

The 6 second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Troubleshooting

To Reset the Timer

If the display is still showing the time remaining, you may change it by touching the Kitchen Timer On/Off pad; then touch the number pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by touching the Kitchen Timer On/Off pad and then touching the number pads to enter the new time you want.

Consumer Support

To Cancel the Timer

Touch the Kitchen Timer On/Off pad twice.

Power Outage

If a flashing time is in the display, you have

To reset the clock, touch the Clock pad.

experienced a power failure. Reset the clock.

Enter the correct time of day by touching

 

the appropriate number pads. Touch the

 

Start pad.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Write the model and serial numbers here Model # Serial # Operating Instructions Safety Instructions Installation ANTI-TIP DeviceAll ranges can tip and injury could result Troubleshooting Tips Consumer SupportGe.com Installation Instructions Tips Operating Instructions Safety InstructionsConsumer Support Safety Installation Instructions Safety InstructionsOperating Instructions Electric Warming Drawer and Lower Oven Drawer Instructions Safety Instructions Operating Installation InstructionsSupport Troubleshooting ConsumerUsing the gas surface burners SafetyTroubleshooting Tips InstructionsUsing the griddle Operating Instructions Safety InstructionsHow to Insert the Griddle Using the GriddleInstructions Installation Case of Power FailureTop-of-Range Cookware Stove Top GrillsUsing the oven controls Touch to select the bake functionUsing the upper oven Instructions OperatingBefore you begin… Upper Oven VentInstructions Safety How to Set the Upper Oven for Baking or RoastingPreheating and Pan Placement Aluminum FoilBroiling Guide Touch the Broil Hi/Lo pad once forHi Broil To change to Lo Broil, touchUsing the clock and timer How to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopOperating Instructions After the oven turns off, the end-of-cycle tone will soundUsing the probe. on some models How to Set the Upper Oven For Cooking When Using the ProbeInsert the probe into the food Touch the Probe padUsing the convection oven. upper oven only Safety InstructionsConvection Bake Convection RoastCookware for Convection Cooking How to Set the Upper Oven for Convection Baking or RoastingPaper and Plastic Safety Instructions Touch the Convection Roast padConvection Roasting Guide-Suggested Settings Meats Minutes/Lb Oven TempTouch the Convection Bake pad Make sure the clock shows the correct time of daySpecial features of your upper oven control Safety InstructionsFahrenheit or Celsius Temperature Selection Hour Shut-OffControl Lockout Cook and HoldHour, 24-Hour or Clock Blackout To lock the controlsHow to Set for Regular Baking/Roasting Using the Sabbath FeatureBe given Touch the Start pad Adjust the upper oven thermostat-Do it yourself How to Exit the Sabbath FeatureTo Adjust the Thermostat Type of margarine will affect baking performanceUsing the lower oven drawer. on some models Operating Instructions SafetyWhen Using the Lower Oven Drawer Warm Zone To Use the Lower Oven DrawerUsing the self-cleaning upper oven Before a Clean CycleHow to Set the Upper Oven for Cleaning Instructions Operating InstructionsAfter a Clean Cycle How to Delay the Start of CleaningCare and cleaning of the range Sealed Burner AssembliesTurn all controls OFF before removing the burner parts Knock over hot cookwareBurner Caps and Heads Cleaning Burner GratesCooktop Surface Glass WindowGriddle Precautions GriddleTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Oven Heating ElementsRemovable Lower Oven Drawer on some models Removable Lower Oven Drawer PanTo remove the drawer To replace the drawer Pull the drawer straight out until it stopsUpper Control Panel Oven Air VentsLower Control Panel and Knobs Oven Light Replacement Oven Shelves and Drawer RacksTo remove Do not remove any screws to remove the coverInstallation of the range Open windows Don’t touch electrical switchesWiring must conform to National Electrical Codes If you smell gasInstallation Instructions Operating Instructions30″ Operating Instructions36″ Operating Instructions Safety Tools YOU will NeedTroubleshooting Tips Consumer Support Gas Supply RequirementsProvide Adequate Gas Supply Recommended Gas Pipe Outlet LocationsElectrical Power Supply Requirements Provide Proper Electrical SupplyRecommended Electrical Outlet Locations 21⁄4″ 71⁄2″Installation Safety InstructionsFlexible Connector Hookup Connect the Range to the Gas SupplyReplace the Power Cord Optional Using an Existing Nema 14-50R ReceptacleDo not discard these screws Wire Power Cord Installation Option Insert the new power cord through the strainWire Conduit Installation Option Tips Consumer Replace the Wire CoverSupport Operating Seal the OpeningsAssemble Surface Burners Check Ignition of Surface BurnersSafety Instructions Operating Instructions Instructions InstallationQuality of Flames Level the RangeInstall the Anti-Tip Device When All Hookups Are CompletedMust be performed by a qualified LP gas installer Regulator Want to convert back to natural gasBefore you call for service… Safety Instructions OperatingTroubleshooting Tips Consumer Support Problem Possible Causes What To DoReset the controls Make sure electrical plug is plugged into a liveDo not work Properly grounded outletSafety Instructions Operating Instructions Installation Heavily soiled ovens may need to self-clean again orFor a longer period of time Touch the Clear/Off pad. Allow the oven to cool forWait for the self-clean cycle to finish and the oven Fan noiseThis is normal. The convection fan will run until Fully extend the drawer and push it all the wayAccessories.ge.com Looking For Something More?Consumer Support Safety Instructions Operating Instructions Consumer Support We’ll Cover Any Appliance. Anywhere Anytime GE Service Protection PlusConsumer Product Ownership Registration GE Dual Fuel Range Warranty GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio

P2B918 specifications

The GE P2B918 is a cutting-edge appliance that exemplifies the intersection of innovative technology and user-centered design. This model stands out due to its advanced features tailored to meet the demands of modern households while promoting energy efficiency and convenience.

At the core of the GE P2B918 is its highly efficient cooling system, which utilizes advanced temperature management technology. This feature ensures that food is stored at optimal temperatures, maintaining freshness and extending shelf life. The cooling system incorporates an advanced air circulation mechanism that prevents warm spots and provides consistent temperatures throughout.

The P2B918 also boasts an intuitive smart control panel, allowing users to easily adjust settings and monitor appliance performance. The digital display provides real-time feedback and notifications about temperature adjustments, making it user-friendly and accessible for everyone in the household. Moreover, the integrated Wi-Fi capability enables remote access through a compatible smartphone app, giving users the ability to manage their appliance from anywhere.

Another impressive characteristic of the GE P2B918 is its spacious interior, creatively designed to maximize storage capacity. The adjustable shelving and specialized compartments cater to various food items, providing flexibility and organization. This organization minimizes clutter and makes it easier to find and access ingredients.

Energy efficiency is a key highlight of the GE P2B918, which is designed to consume less energy while providing maximum performance. It adheres to stringent energy guidelines, helping consumers save on electricity bills while supporting eco-friendly initiatives. Additionally, the appliance employs LED lighting that enhances visibility inside the refrigerator, consuming less energy than traditional bulbs.

In terms of aesthetics, the GE P2B918 presents a sleek, modern design that fits seamlessly into contemporary kitchens. Available in a variety of finishes, including stainless steel and matte colors, it offers options for different decor styles while ensuring durability and easy maintenance.

With its combination of innovative features, superior technology, and stylish design, the GE P2B918 stands out as an exceptional choice for consumers seeking a reliable and efficient appliance that enhances their kitchen experience. Whether it's its cooling technology, smart controls, or energy-efficient capabilities, the P2B918 embodies what modern appliances should aspire to be.
Top Page Image Contents