GE P2B918 installation instructions Burner Caps and Heads

Page 32

Care and cleaning of the range.

Operating Instructions Safety Instructions

Installation

Instructions

 

 

Troubleshooting Tips

Burner heads

Slot

Electrode

The burner heads are removable. Simply lift them off the range for cleaning.

Hole in burner head

The oval burner head/cap assembly is removable. Simply lift it off the range for cleaning. Use a sewing needle or twist-tie to unclog the small hole in the burner heads.

Burner Caps and Heads

Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning.

NOTE: Do not use steel wool or scouring powders to clean the burner parts.

Burner caps

Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Burner Heads and Oval (Center) Burner Head/Cap Assembly

The burner heads and the oval burner head/cap assembly are removable. Simply lift them off the range for cleaning.

For proper ignition, make sure the

small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads must be kept clean at all times for an even, unhampered flame.

Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.

Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.

Clean the burner heads routinely, especially after bad spillovers, which could clog the openings. Lift off when cool.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains, use a toothbrush.

After cleaning

Before putting the burner caps, heads and oval head/cap assembly back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.

Replacement

Burner Heads

Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size. There is one small, one medium, one large and one extra large burner head.

Medium head

 

Small head

Large head

 

 

 

 

 

 

 

 

 

 

 

Extra large

 

 

 

 

 

 

 

 

 

 

 

 

Front of range

 

 

 

 

 

 

 

 

head

 

 

 

 

 

 

 

 

 

 

 

 

Make sure the slot in the burner head is positioned over the electrode.

Electrode Slot

Oval (Center) Burner Head/Cap Assembly

Replace the oval (center) head/cap assembly over the electrode on the cooktop.

Oval head and cap

Make sure the slot in

assembly

the burner head is

 

positioned over the

 

electrode.

Slot

Front of range

Electrode

Caps

Replace the matching size caps onto the burner bases or heads.

Consumer Support

Medium cap

Large cap

Small cap

 

 

 

 

 

 

 

 

 

 

 

Extra large

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Front of range

 

 

 

cap

Make sure that the heads and caps are replaced in the correct locations.

32

Image 32
Contents Write the model and serial numbers here Model # Serial # Operating Instructions Safety Instructions Installation ANTI-TIP DeviceGe.com Troubleshooting Tips Consumer SupportAll ranges can tip and injury could result Consumer Support Operating Instructions Safety InstructionsInstallation Instructions Tips Safety Operating Instructions Safety InstructionsInstallation Instructions Electric Warming Drawer and Lower Oven Drawer Instructions Safety Instructions Operating Installation InstructionsSupport Troubleshooting ConsumerUsing the gas surface burners SafetyTroubleshooting Tips InstructionsUsing the griddle Operating Instructions Safety InstructionsHow to Insert the Griddle Using the GriddleInstructions Installation Case of Power FailureTop-of-Range Cookware Stove Top GrillsUsing the oven controls Touch to select the bake functionUsing the upper oven Instructions OperatingBefore you begin… Upper Oven VentInstructions Safety How to Set the Upper Oven for Baking or RoastingPreheating and Pan Placement Aluminum FoilBroiling Guide Touch the Broil Hi/Lo pad once forHi Broil To change to Lo Broil, touchUsing the clock and timer How to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopOperating Instructions After the oven turns off, the end-of-cycle tone will soundUsing the probe. on some models How to Set the Upper Oven For Cooking When Using the ProbeInsert the probe into the food Touch the Probe padUsing the convection oven. upper oven only Safety InstructionsConvection Bake Convection RoastPaper and Plastic How to Set the Upper Oven for Convection Baking or RoastingCookware for Convection Cooking Safety Instructions Touch the Convection Roast padConvection Roasting Guide-Suggested Settings Meats Minutes/Lb Oven TempTouch the Convection Bake pad Make sure the clock shows the correct time of daySpecial features of your upper oven control Safety InstructionsFahrenheit or Celsius Temperature Selection Hour Shut-OffControl Lockout Cook and HoldHour, 24-Hour or Clock Blackout To lock the controlsBe given Touch the Start pad Using the Sabbath FeatureHow to Set for Regular Baking/Roasting Adjust the upper oven thermostat-Do it yourself How to Exit the Sabbath FeatureTo Adjust the Thermostat Type of margarine will affect baking performanceUsing the lower oven drawer. on some models Operating Instructions SafetyWhen Using the Lower Oven Drawer Warm Zone To Use the Lower Oven DrawerUsing the self-cleaning upper oven Before a Clean CycleHow to Set the Upper Oven for Cleaning Instructions Operating InstructionsAfter a Clean Cycle How to Delay the Start of CleaningCare and cleaning of the range Sealed Burner AssembliesTurn all controls OFF before removing the burner parts Knock over hot cookwareBurner Caps and Heads Cleaning Burner GratesCooktop Surface Glass WindowGriddle Precautions GriddleTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Oven Heating ElementsRemovable Lower Oven Drawer on some models Removable Lower Oven Drawer PanTo remove the drawer To replace the drawer Pull the drawer straight out until it stopsLower Control Panel and Knobs Oven Air VentsUpper Control Panel Oven Light Replacement Oven Shelves and Drawer RacksTo remove Do not remove any screws to remove the coverInstallation of the range Open windows Don’t touch electrical switchesWiring must conform to National Electrical Codes If you smell gasInstallation Instructions Operating Instructions36″ Operating Instructions30″ Operating Instructions Safety Tools YOU will NeedTroubleshooting Tips Consumer Support Gas Supply RequirementsProvide Adequate Gas Supply Recommended Gas Pipe Outlet LocationsElectrical Power Supply Requirements Provide Proper Electrical SupplyRecommended Electrical Outlet Locations 21⁄4″ 71⁄2″Installation Safety InstructionsFlexible Connector Hookup Connect the Range to the Gas SupplyDo not discard these screws Using an Existing Nema 14-50R ReceptacleReplace the Power Cord Optional Wire Power Cord Installation Option Insert the new power cord through the strainWire Conduit Installation Option Support Replace the Wire CoverTips Consumer Operating Seal the OpeningsAssemble Surface Burners Check Ignition of Surface BurnersSafety Instructions Operating Instructions Instructions InstallationQuality of Flames Level the RangeInstall the Anti-Tip Device When All Hookups Are CompletedMust be performed by a qualified LP gas installer Regulator Want to convert back to natural gasBefore you call for service… Safety Instructions OperatingTroubleshooting Tips Consumer Support Problem Possible Causes What To DoReset the controls Make sure electrical plug is plugged into a liveDo not work Properly grounded outletSafety Instructions Operating Instructions Installation Heavily soiled ovens may need to self-clean again orFor a longer period of time Touch the Clear/Off pad. Allow the oven to cool forWait for the self-clean cycle to finish and the oven Fan noiseThis is normal. The convection fan will run until Fully extend the drawer and push it all the wayAccessories.ge.com Looking For Something More?Consumer Support Safety Instructions Operating Instructions Consumer Support We’ll Cover Any Appliance. Anywhere Anytime GE Service Protection PlusConsumer Product Ownership Registration GE Dual Fuel Range Warranty GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio

P2B918 specifications

The GE P2B918 is a cutting-edge appliance that exemplifies the intersection of innovative technology and user-centered design. This model stands out due to its advanced features tailored to meet the demands of modern households while promoting energy efficiency and convenience.

At the core of the GE P2B918 is its highly efficient cooling system, which utilizes advanced temperature management technology. This feature ensures that food is stored at optimal temperatures, maintaining freshness and extending shelf life. The cooling system incorporates an advanced air circulation mechanism that prevents warm spots and provides consistent temperatures throughout.

The P2B918 also boasts an intuitive smart control panel, allowing users to easily adjust settings and monitor appliance performance. The digital display provides real-time feedback and notifications about temperature adjustments, making it user-friendly and accessible for everyone in the household. Moreover, the integrated Wi-Fi capability enables remote access through a compatible smartphone app, giving users the ability to manage their appliance from anywhere.

Another impressive characteristic of the GE P2B918 is its spacious interior, creatively designed to maximize storage capacity. The adjustable shelving and specialized compartments cater to various food items, providing flexibility and organization. This organization minimizes clutter and makes it easier to find and access ingredients.

Energy efficiency is a key highlight of the GE P2B918, which is designed to consume less energy while providing maximum performance. It adheres to stringent energy guidelines, helping consumers save on electricity bills while supporting eco-friendly initiatives. Additionally, the appliance employs LED lighting that enhances visibility inside the refrigerator, consuming less energy than traditional bulbs.

In terms of aesthetics, the GE P2B918 presents a sleek, modern design that fits seamlessly into contemporary kitchens. Available in a variety of finishes, including stainless steel and matte colors, it offers options for different decor styles while ensuring durability and easy maintenance.

With its combination of innovative features, superior technology, and stylish design, the GE P2B918 stands out as an exceptional choice for consumers seeking a reliable and efficient appliance that enhances their kitchen experience. Whether it's its cooling technology, smart controls, or energy-efficient capabilities, the P2B918 embodies what modern appliances should aspire to be.