GE P2B918 installation instructions Tips Consumer, Support, Replace the Wire Cover

Page 49

Read these instructions completely and carefully.

Replace the Power Cord (Optional) Continued

Perform this step only if the power cord shipped on the range does not match your wall receptacle.

4-Wire Conduit Installation Option

Safety Instructions

Remove the strain relief clamp from the bracket.

Assemble the squeeze connector (obtained locally), matching the diameter of your conduit, in the bracket hole. Insert the conduit through the squeeze connector. Allow enough slack to easily attach the wires to the terminal block.

NOTE: Do not install the conduit without a squeeze connector.

Insert the ground bare wire tip between the range frame and the ground plate (removed earlier) and secure it in place with the ground screw (removed earlier). Insert the bare wire (white/neutral) tip through the bottom center of the terminal block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secure (approximately 20 inch-lbs.).

NOTE: Make sure the wire is completely inserted into the terminal block and a secure connection is made.

Secure the squeeze connector in place in the bracket by tightening the squeeze connector screws.

Squeeze connector

Conduit

Terminal block

Wire tips

Ground screw

Bracket

Ground plate (grounding to range)

Bracket

Operating Instructions

Instructions

Installation

 

 

NOTE: ALUMINUM WIRING:

 

Aluminum building wire may be used but it must be

Wire used, location and enclosure

of splices, etc., must conform to good wiring

rated for the correct amperage and voltage to

practices and local codes.

make connection.

 

Troubleshooting

Replace the Wire Cover

Replace the wire cover on the range back by sliding its right edge under the retaining tab and replacing the two screws removed earlier. Make sure that no wires are pinched between the cover and the range back.

Retaining

2 screws

tab

to replace

 

wire cover

 

Wire cover

Tips Consumer

Back of range

49

Support

Image 49
Contents Write the model and serial numbers here Model # Serial # ANTI-TIP Device Operating Instructions Safety Instructions InstallationAll ranges can tip and injury could result Troubleshooting Tips Consumer SupportGe.com Installation Instructions Tips Operating Instructions Safety InstructionsConsumer Support Safety Installation Instructions Safety InstructionsOperating Instructions Electric Warming Drawer and Lower Oven Drawer Operating Installation Instructions Instructions Safety InstructionsSupport Troubleshooting ConsumerSafety Using the gas surface burnersTroubleshooting Tips InstructionsOperating Instructions Safety Instructions Using the griddleHow to Insert the Griddle Using the GriddleCase of Power Failure Instructions InstallationTop-of-Range Cookware Stove Top GrillsTouch to select the bake function Using the oven controlsInstructions Operating Using the upper ovenBefore you begin… Upper Oven VentHow to Set the Upper Oven for Baking or Roasting Instructions SafetyPreheating and Pan Placement Aluminum FoilTouch the Broil Hi/Lo pad once for Broiling GuideHi Broil To change to Lo Broil, touchUsing the clock and timer How to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopOperating Instructions After the oven turns off, the end-of-cycle tone will soundHow to Set the Upper Oven For Cooking When Using the Probe Using the probe. on some modelsInsert the probe into the food Touch the Probe padSafety Instructions Using the convection oven. upper oven onlyConvection Bake Convection RoastCookware for Convection Cooking How to Set the Upper Oven for Convection Baking or RoastingPaper and Plastic Touch the Convection Roast pad Safety InstructionsMeats Minutes/Lb Oven Temp Convection Roasting Guide-Suggested SettingsMake sure the clock shows the correct time of day Touch the Convection Bake padSafety Instructions Special features of your upper oven controlFahrenheit or Celsius Temperature Selection Hour Shut-OffCook and Hold Control LockoutHour, 24-Hour or Clock Blackout To lock the controlsHow to Set for Regular Baking/Roasting Using the Sabbath FeatureBe given Touch the Start pad How to Exit the Sabbath Feature Adjust the upper oven thermostat-Do it yourselfTo Adjust the Thermostat Type of margarine will affect baking performanceOperating Instructions Safety Using the lower oven drawer. on some modelsWhen Using the Lower Oven Drawer Warm Zone To Use the Lower Oven DrawerBefore a Clean Cycle Using the self-cleaning upper ovenHow to Set the Upper Oven for Cleaning Instructions Operating InstructionsHow to Delay the Start of Cleaning After a Clean CycleSealed Burner Assemblies Care and cleaning of the rangeTurn all controls OFF before removing the burner parts Knock over hot cookwareBurner Caps and Heads Burner Grates CleaningCooktop Surface Glass WindowGriddle Griddle PrecautionsTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Oven Heating ElementsRemovable Lower Oven Drawer Pan Removable Lower Oven Drawer on some modelsTo remove the drawer To replace the drawer Pull the drawer straight out until it stopsUpper Control Panel Oven Air VentsLower Control Panel and Knobs Oven Shelves and Drawer Racks Oven Light ReplacementTo remove Do not remove any screws to remove the coverOpen windows Don’t touch electrical switches Installation of the rangeWiring must conform to National Electrical Codes If you smell gasOperating Instructions Installation Instructions30″ Operating Instructions36″ Tools YOU will Need Operating Instructions SafetyGas Supply Requirements Troubleshooting Tips Consumer SupportProvide Adequate Gas Supply Recommended Gas Pipe Outlet LocationsProvide Proper Electrical Supply Electrical Power Supply RequirementsRecommended Electrical Outlet Locations 21⁄4″ 71⁄2″Safety Instructions InstallationFlexible Connector Hookup Connect the Range to the Gas SupplyReplace the Power Cord Optional Using an Existing Nema 14-50R ReceptacleDo not discard these screws Insert the new power cord through the strain Wire Power Cord Installation OptionWire Conduit Installation Option Tips Consumer Replace the Wire CoverSupport Seal the Openings OperatingAssemble Surface Burners Check Ignition of Surface BurnersInstructions Installation Safety Instructions Operating InstructionsQuality of Flames Level the RangeWhen All Hookups Are Completed Install the Anti-Tip DeviceMust be performed by a qualified LP gas installer Regulator Want to convert back to natural gasSafety Instructions Operating Before you call for service…Troubleshooting Tips Consumer Support Problem Possible Causes What To DoMake sure electrical plug is plugged into a live Reset the controlsDo not work Properly grounded outletHeavily soiled ovens may need to self-clean again or Safety Instructions Operating Instructions InstallationFor a longer period of time Touch the Clear/Off pad. Allow the oven to cool forFan noise Wait for the self-clean cycle to finish and the ovenThis is normal. The convection fan will run until Fully extend the drawer and push it all the wayLooking For Something More? Accessories.ge.comConsumer Support Safety Instructions Operating Instructions Consumer Support GE Service Protection Plus We’ll Cover Any Appliance. Anywhere AnytimeConsumer Product Ownership Registration GE Will Replace GE Dual Fuel Range WarrantyWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio

P2B918 specifications

The GE P2B918 is a cutting-edge appliance that exemplifies the intersection of innovative technology and user-centered design. This model stands out due to its advanced features tailored to meet the demands of modern households while promoting energy efficiency and convenience.

At the core of the GE P2B918 is its highly efficient cooling system, which utilizes advanced temperature management technology. This feature ensures that food is stored at optimal temperatures, maintaining freshness and extending shelf life. The cooling system incorporates an advanced air circulation mechanism that prevents warm spots and provides consistent temperatures throughout.

The P2B918 also boasts an intuitive smart control panel, allowing users to easily adjust settings and monitor appliance performance. The digital display provides real-time feedback and notifications about temperature adjustments, making it user-friendly and accessible for everyone in the household. Moreover, the integrated Wi-Fi capability enables remote access through a compatible smartphone app, giving users the ability to manage their appliance from anywhere.

Another impressive characteristic of the GE P2B918 is its spacious interior, creatively designed to maximize storage capacity. The adjustable shelving and specialized compartments cater to various food items, providing flexibility and organization. This organization minimizes clutter and makes it easier to find and access ingredients.

Energy efficiency is a key highlight of the GE P2B918, which is designed to consume less energy while providing maximum performance. It adheres to stringent energy guidelines, helping consumers save on electricity bills while supporting eco-friendly initiatives. Additionally, the appliance employs LED lighting that enhances visibility inside the refrigerator, consuming less energy than traditional bulbs.

In terms of aesthetics, the GE P2B918 presents a sleek, modern design that fits seamlessly into contemporary kitchens. Available in a variety of finishes, including stainless steel and matte colors, it offers options for different decor styles while ensuring durability and easy maintenance.

With its combination of innovative features, superior technology, and stylish design, the GE P2B918 stands out as an exceptional choice for consumers seeking a reliable and efficient appliance that enhances their kitchen experience. Whether it's its cooling technology, smart controls, or energy-efficient capabilities, the P2B918 embodies what modern appliances should aspire to be.