Conversion & Orifices Information

BAKE BURNER

ADJUSTMENTS

Loosen

Air Adjustment

Shutter

Air Adjustment

Shutter

Loosen

BROIL BURNER ADJUSTMENTS

6Open the bake and broil air shutter adjustments as far as possible and adjust later if necessary.

Beneath the bake and broil burner orifice hoods are LP orifice needles. To convert to L.P. tighten the orifice hoods against the orifice needle until the hoods are snug (2-2½ turns). DO NOT OVER TIGHTEN. Check the burners for proper flame adjustment. The burner flame should have approximately 1" blue cones. With most LP gas, small yellow tips at the end of outer cones are normal. flames should not lift off burner ports. If lifting is observed, gradually reduce the air shutter opening until flames are stabilized.

BURNER OUTPUT RATINGS; BTU/HR

NATURAL GAS with 4" W.C.P.

Burner	BTU Rate	Orifice Size

LF, RF	12,000	1.68 mm (III)

LR	9,500	1.50 mm (II)

RR	5,000	1.07 mm (I)

BAKE	16,000	#47 (.0785")

BROIL	13,500	(.069")

175Natural gas surface

N	orifices are marked
III	on top as shown
III

ORIFICE INFORMATION

JGBP85BEA Orifice Charts

TOP BURNER ORIFICES

LR	RR
LF	RF

GAS

Front of Range

The top burner orifices each have a series of marks engraved on the tops of the orifices (I, II, III) to denote their location. The marks appear on both the Natural and LP gas orifices. The location indicated by the marks, is the same for both gases.

See BURNER OUTPUT RATING charts at right for locations.

BURNER OUTPUT RATINGS; BTU/HR

LP (PROPANE) GAS with 10" W.C.P.

Burner	BTU Rate	Orifice Size

LF, RF	11,000	.94L mm		(III)

LR	9,500	.89L mm		(II)

RR	5,000	.63L	MM	(I)

BAKE	16,000	#56	(.0465")

BROIL	12,000	#59	(.041")

90LP gas surface

L	orifices are marked
III	on top as shown
III

SMALLER ORIFICES FOR HIGHER ELEVATIONS

Burner	Size	Part Number	L.P.	Natural

LF & RF	1.65 mm	WB02X9841

LF & RF	.84 mm	WB02K0022

LR	1.44 mm	WB06K0094

LR	.73 mm	WB19K5000

IMPORTANT NOTE: Always consult the Technical Service literature (mini-manual) enclosed with the appliance for model specific conversion information

– 12 –

LP ORIFICE COLOR ID

Burner	BTU Rate	Color

LF & RF	11,000 BTU	Blue / Magenta

LR	9,500 BTU	Blue / Brown

RR	5,000 BTU	Blue / Blue

Paint color codes have been added to the sides of the LP orifices to aid in identifying the proper orifice location during conver- sion.