GE JGBP33SEMSS Display goes blank, Display flashes, Unable to get, Display to show SF, Fan noise

Page 49

ge.com

Problem		Possible Causes	What To Do

Display goes blank		A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
(on some models)		blown or the circuit
		breaker tripped.

		The clock is turned off so that it	• See the Using the clock and timer section.
		does not show in the display.

Display flashes		Power failure.	• Reset the clock.
(on some models)

Unable to get the		Oven control pads were	• The Bake and Broil Hi/Lo pads must be touched at
display to show “SF”		not touched properly.	the same time and held for 3 seconds.
(on some models)

Power outage,		Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes			it by touching the Clear/Off pad, setting the clock and
(on some models)			resetting any cooking function.

“Burning” or “oily” odor		This is normal in a new oven	• To speed the process, set a self-clean cycle for a
emitting from the vent		and will disappear in time.	minimum of 3 hours. See the Using the self-cleaning
			oven section.

Strong odor		An odor from the insulation	• This is temporary.
		around the inside of the oven
		is normal for the first few times
		the oven is used.

Fan noise		A cooling fan may automatically	• This is normal. The cooling fan will turn off and on.
		turn on and off to cool
		internal parts.

Drawer does not slide		The drawer is out of alignment.	• Fully extend the drawer and push it all the way in.
smoothly or drags			See the Care and cleaning of the range section.

		Drawer is over-loaded or load	• Reduce weight. Redistribute drawer contents.
		is unbalanced.

Safety Instructions

Instructions	Operating

Care and Cleaning

Instructions	Installation

Troubleshooting Tips

49

Consumer Support

Image 49

Contents

Write the model and serial numbers here Model # Serial # Ge.comWhat to do if YOU Smell GAS Ge.com Installation InstructionsSafety Precautions Instructions Surface BurnersCook Meat and Poultry THOROUGHLY… Operating Instructions Electric Warming Drawer on some modelsHow to Select Flame Size Using the gas surface burnersBefore Lighting a Gas Burner Sealed Gas BurnersTop-of-Range Cookware Case of Power FailureCare Using the oven controlsOven Temperature Knob on some models Oven Vent Before you begin…Preheating and Pan Placement How to Set the Oven for Baking or RoastingTroubleshooting Tips Consumer Support Aluminum FoilHow to Set the Oven for Broiling Using the ovenBroiling Guide Hi BroilTo Set the Timer Using the clock and timer. on some modelsTo Set the Clock To Turn Off the Clock DisplayTo Cancel the Timer To Reset the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopHour Shut-Off Special features of your oven control. on some modelsHow to Set for Regular Baking/Roasting Using the Sabbath Feature. on some modelsDesigned for use on the Jewish Sabbath and Holidays Operating Instructions To Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat on models with an Oven Temp Knob Care and CleaningOn Signal Light When Using the Warming DrawerTo Crisp Stale Items Temperature Selection ChartBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning To Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Standard Twin Burner Assemblies on some models Care and cleaning of the rangeInstructions Burner caps Burner Caps and HeadsCooktop Surface Burner GratesStainless Steel Surfaces on some models Lift-Off Oven Door To clean the inside of the doorOven Bottom Removable Kick Panel on some models Removable Storage Drawer on some models Safety InstructionsRemovable Warming Drawer on some models Lower Control Panel Front Manifold Panel and Knobs Oven Air VentsTo raise the cooktop Oven Shelves Oven Light ReplacementDo not remove any screws to remove the cover To replace coverPart Included For Your SafetyTools YOU will Need Materials YOU MAY NeedInstallation Instructions Dimensions and Clearances Location ANTI-TIP DeviceProvide Adequate GAS Supply Connect the Range to GASInstallation Instructions Rigid Pipe Hookup Options Pressure regulator Manifold pipe Electrical Requirements Electrical ConnectionsSeal the Openings Check Ignition of Surface BurnersCheck Ignition of Oven Burner To remove the oven bottom Leveling the Range When ALL Hookups are Completed Installing the ANTI-TIP DeviceBefore you call for service… See the Care and cleaning of the range section See the Using the clock and timer sectionSee the Installation of the range section Oven temperatureClean cycle After a clean cycle Oven not clean afterSelf clean light on When trying to set aDisplay goes blank Power outageDisplay flashes Unable to getCare and Cleaning We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Looking For Something More? AccessoriesWhat GE Will Not Cover GE Will ReplaceOne Year Mabe Will Replace Care and CleaningWhat Mabe Will Not Cover Parts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio