GE JGB428SERSS, 49-85179 Using the oven controls, Touch this pad to select the bake function

Page 10

Safety Instructions

 

Operating Instructions

 

Cleaning

Using the oven controls.

Throughout this manual, features and appearance may vary from your model.

Oven Control, Clock and Timer Features and Settings (on some models)

Care and

 

Installation Instructions

 

Bake/Temp Recall Pad

Touch this pad to select the bake function.

Bake Light

Flashes while in edit mode—you can change the oven temperature at this point. Glows when the oven is in bake mode.

Start/On Pad

Must be touched to start any cooking or cleaning function.

Display

Shows the time of day, oven temperature, whether the oven is in the bake, broil or self-cleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature.

Kitchen Timer On/Off Pad

Touch this pad to select the timer feature.

Then press the + and – pads to adjust the timer.

Timer Light

Flashes while in edit mode—you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset.

Clock Pad

To set the clock, press this pad twice and then press the + and – pads. The time of day will flash in the display when the oven is first turned on.

Start Time Pad (on some models)

Use along with the Cooking Time or Self Clean pads to set the oven to start and stop automatically at a time you set.

Troubleshooting Tips

 

Consumer Support

 

 

If “F–” and a number or letter flash in the display

 

and the oven control signals, this indicates a function

 

error code.

 

If your oven was set for a timed oven operation and a

 

power outage occurred, the clock and all programmed

 

functions must be reset.

 

The time of day will flash in the display when there has

 

been a power outage. Reset the clock.

 

If the function error code appears during the self-

 

cleaning cycle, check the oven door latch. The latch

 

handle may have been moved, even if only slightly,

 

from the latched position. Make sure the latch is moved

 

to the right as far as it will go.

 

Touch the Clear/Off pad. allow the oven to cool for

 

one hour. Put the oven back into operation. If the

10

function error code repeats, disconnect the power to

the range and call for service.

Start Time Light

Flashes while in edit mode—you can change the start time at this point. Glows when the function has been activated.

Cooking Time Pad (on some models)

Touch this pad and then touch the + or – pads to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out.

Cooking Time Light

Flashes while in edit mode—you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Write the model and serial numbers here Model # Serial # Safety Instructions Smell GASIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS GLaSS Cooktop SURFaCe on some models OVeN Using the gas surface burners Operating InstructionsTop-of-Range Cookware Case of Power FailureCare Must be touched to start any cooking or cleaning function Using the oven controlsTouch this pad to select the bake function Touch this pad to turn the oven light on or off Safety InstructionsOr temperature by larger amounts Touch this pad to select the broil functionBefore you begin… SafetyOven Vent Preheating and Pan Placement Using the upper ovenHow to Set the Upper Oven for Baking or Roasting Aluminum FoilHi Broil How to Set the Oven for BroilingPlace the meat or fish on a broiler grid in a broiler pan To change to Lo Broil, touchTouch the Kitchen Timer On/Off pad Using the clock and timer. on some modelsTo Set the Timer To Set the ClockPower Outage To Reset the TimerTo Cancel the Timer OperatingHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowCare and Cleaning Installation Instructions Using the Sabbath feature. on some modelsDesigned for use on the Jewish Sabbath and Holidays Designed for use on the Jewish Sabbath and Holidays Type of margarine will affect baking performance Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat on some models Touch the Bake pad. a two-digit number shows in the displayBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning To Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Care and cleaning of the range Sealed Burner AssembliesCare and Cleaning Burner Caps and HeadsCleaning Do not use a steel-wool pad it will scratch the surfaceBurned-On Residue CareHeavy, Burned-On Residue Damage from Sugary Spills and Melted Plastic Cleaning the glass cooktop. on some modelsCooktop Seal To Order PartsLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Oven BottomLower Control Panel Front Manifold Panel and Knobs Oven Light ReplacementOven Racks ToolS yoU wIll nEED FoR yoUR SAFETyPart InClUDED MATERIAlS yoU MAy nEEDInstallation Instructions DIMEnSIonS AnD ClEARAnCES 0Minimum473⁄8 PRoVIDE ADEqUATE GAS SUPPly LoCATIonConnECT the RAnGE To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe ElECTRICAl ConnECTIonS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit SEAl the oPEnInGS ASSEMBlE Surface BURnERSAssemble the burners as shown Check oPERATIon oF oVEn BURnERS Check oPERATIon oF Surface BURnERSWith LP gas, some yellow tipping on outer cones is normal LEVElInG the RAnGE Check IGnITIon oF oVEn BURnERSIf nECESSARy OtherInSTAllInG the AnTI-TIP Device WHEn All HooKUPS are CoMPlETEDPage Before you call for service… Or roast properly Rack position is incorrect Entering cooking time or temperature or cleaning timeLight colored glass cooktop Incorrect cookware or cookwareTips Check the oven door latch You have a function error code Door appears Self-cleaning cycle has beenDuring the self-cleaning cycle Power outage Power outage or surgeAccessories Limited Time Offer! Free ShippingWhat GE Will Not Cover Consumer SupportGE Will Replace One YearMabe Will Replace What Mabe Will Not CoverSchedule Service Consumer Support

JGB428, JGB428SERSS, 49-85179 specifications

The GE 49-85179, JGB428SERSS, and JGB428 are part of General Electric's innovative line of kitchen appliances, particularly focusing on ranges that enhance the cooking experience while providing reliable performance. These models are particularly known for their blend of advanced technology, user-friendly design, and energy efficiency.

The GE 49-85179 is a freestanding gas range that boasts a sleek and modern design, making it suitable for any contemporary kitchen. One of its standout features is the innovative edge-to-edge cooktop, which offers a larger cooking surface for more cooking flexibility. With up to five burners, including a powerful 18,000 BTU burner, the range allows for rapid boiling, sautéing, and simmering. This makes it an ideal appliance for both home cooks and culinary enthusiasts who demand performance.

The incorporation of the Convection Bake feature in the GE 49-85179 ensures even baking results, with hot air circulating within the oven, thus eliminating hot spots. This technology allows for faster cooking times and improved food consistency, making it easier to deliver perfectly cooked meals. The range to also achieves precise temperature control, ensuring that users can attain the perfect cooking conditions for a variety of dishes.

Similarly, the JGB428SERSS model emphasizes both functionality and aesthetics. This gas range features a large oven capacity, perfect for cooking multiple dishes at once. The self-cleaning feature saves time and effort, allowing users to maintain their appliance with minimal hassle. Its oven includes baking and broiling elements that provide heat from both the top and bottom, allowing chefs to achieve restaurant-quality results right at home.

The JGB428 also highlights GE's commitment to energy efficiency, utilizing advanced technology to reduce power consumption while still delivering powerful cooking performance. With an intuitive digital display and straightforward controls, this model is designed for seamless user interaction, making it easier to set cooking times, temperatures, and select different cooking modes.

In summary, the GE 49-85179 and its counterparts—the JGB428SERSS and JGB428—are characterized by their smart design, advanced cooking technologies, and energy efficiency. Together, they represent a commitment to enhancing the culinary experience, providing home cooks with the tools they need to create delicious meals with confidence and ease. With these ranges, General Electric continues to innovate in the realm of home cooking appliances.
Top Page Image Contents