GE JGB428SERSS, 49-85179 installation instructions Care and Cleaning, Burner Caps and Heads

Page 25

GEAppliances.com

Safety

Burner Caps and Heads

NOTE: Before removing the burner caps

and heads, remember their size and location. Replace them in the same location after cleaning. The top sides of the Right Front, Right Rear and Left Front burner heads are marked with the letters “RF,” “RR” and “LF,” respectively, to aid reassembly.

Burner caps

Lift off when cool. Wash burner caps

in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on

Replacement

The top sides of the Right Front, Right Rear and Left Front burner heads are marked with the letters “RF,” “RR” and “LF,” respectively, to aid reassembly.

Medium head

 

(not marked)

Small head

and cap

and cap

Instructions

 

Operating Instructions

food particles.

Burner heads

The slits in the burner heads of your cooktop must be kept clean at all times.

Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.

Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.

LF

Front of

range

Large head and cap

RR

RF

Extra large head and cap

Care and Cleaning

You should clean the burner caps, burner heads and burner bases routinely, especially after bad spillovers, which could clog the openings in the burner heads.

Lift off when cool.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains,

use a toothbrush.

After cleaning

Before putting the burner caps and heads back, shake out excess water and then

dry them thoroughly by setting in a warm oven for 30 minutes.

NOTE: Do not use steel wool or scouring powders to clean the burners or electrodes. This can damage the burners and electrically short the electrodes.

Replace the burner heads on the bases matching the letters. Replace the caps on the heads. Make sure that the caps and heads are replaced in the correct location. There is one small, one medium, one large and one extra large head and cap.

Locator pins

Pin slots

When replacing, make sure the locator pins in the burner head are seated in the pin slots of the burner base. Rotate the burner head around the burner base until it is level and securely seated.

Instructions

Installation

Tips

Troubleshooting

Consumer Support

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Write the model and serial numbers here Model # Serial # Smell GAS Safety InstructionsGEAppliances.com IMPORTaNT SaFeTY NOTICeAppliance as a space heater to heat or SURFaCe BURNeRS GLaSS Cooktop SURFaCe on some models OVeN Operating Instructions Using the gas surface burnersTop-of-Range Cookware Case of Power FailureCare Must be touched to start any cooking or cleaning function Using the oven controlsTouch this pad to select the bake function Or temperature by larger amounts Safety InstructionsTouch this pad to turn the oven light on or off Touch this pad to select the broil functionBefore you begin… SafetyOven Vent How to Set the Upper Oven for Baking or Roasting Using the upper ovenPreheating and Pan Placement Aluminum FoilPlace the meat or fish on a broiler grid in a broiler pan How to Set the Oven for BroilingHi Broil To change to Lo Broil, touchTo Set the Timer Using the clock and timer. on some modelsTouch the Kitchen Timer On/Off pad To Set the ClockTo Cancel the Timer To Reset the TimerPower Outage OperatingHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopIf you wish to turn OFF this feature, follow the steps below Special features of your oven control. on some modelsCare and Cleaning Installation Instructions Using the Sabbath feature. on some modelsDesigned for use on the Jewish Sabbath and Holidays Designed for use on the Jewish Sabbath and Holidays To Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfType of margarine will affect baking performance Touch the Bake pad. a two-digit number shows in the displayBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning To Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Sealed Burner Assemblies Care and cleaning of the rangeBurner Caps and Heads Care and CleaningDo not use a steel-wool pad it will scratch the surface CleaningBurned-On Residue CareHeavy, Burned-On Residue Cooktop Seal Cleaning the glass cooktop. on some modelsDamage from Sugary Spills and Melted Plastic To Order PartsTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Oven BottomLower Control Panel Front Manifold Panel and Knobs Oven Light ReplacementOven Racks Part InClUDED FoR yoUR SAFETyToolS yoU wIll nEED MATERIAlS yoU MAy nEEDInstallation Instructions 0Minimum DIMEnSIonS AnD ClEARAnCES473⁄8 PRoVIDE ADEqUATE GAS SUPPly LoCATIonConnECT the RAnGE To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe ElECTRICAl ConnECTIonS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit SEAl the oPEnInGS ASSEMBlE Surface BURnERSAssemble the burners as shown Check oPERATIon oF oVEn BURnERS Check oPERATIon oF Surface BURnERSWith LP gas, some yellow tipping on outer cones is normal If nECESSARy Check IGnITIon oF oVEn BURnERSLEVElInG the RAnGE OtherWHEn All HooKUPS are CoMPlETED InSTAllInG the AnTI-TIP DevicePage Before you call for service… Light colored glass cooktop Entering cooking time or temperature or cleaning timeOr roast properly Rack position is incorrect Incorrect cookware or cookwareTips During the self-cleaning cycle Door appears Self-cleaning cycle has beenCheck the oven door latch You have a function error code Power outage Power outage or surgeLimited Time Offer! Free Shipping AccessoriesGE Will Replace Consumer SupportWhat GE Will Not Cover One YearWhat Mabe Will Not Cover Mabe Will ReplaceConsumer Support Schedule Service

JGB428, JGB428SERSS, 49-85179 specifications

The GE 49-85179, JGB428SERSS, and JGB428 are part of General Electric's innovative line of kitchen appliances, particularly focusing on ranges that enhance the cooking experience while providing reliable performance. These models are particularly known for their blend of advanced technology, user-friendly design, and energy efficiency.

The GE 49-85179 is a freestanding gas range that boasts a sleek and modern design, making it suitable for any contemporary kitchen. One of its standout features is the innovative edge-to-edge cooktop, which offers a larger cooking surface for more cooking flexibility. With up to five burners, including a powerful 18,000 BTU burner, the range allows for rapid boiling, sautéing, and simmering. This makes it an ideal appliance for both home cooks and culinary enthusiasts who demand performance.

The incorporation of the Convection Bake feature in the GE 49-85179 ensures even baking results, with hot air circulating within the oven, thus eliminating hot spots. This technology allows for faster cooking times and improved food consistency, making it easier to deliver perfectly cooked meals. The range to also achieves precise temperature control, ensuring that users can attain the perfect cooking conditions for a variety of dishes.

Similarly, the JGB428SERSS model emphasizes both functionality and aesthetics. This gas range features a large oven capacity, perfect for cooking multiple dishes at once. The self-cleaning feature saves time and effort, allowing users to maintain their appliance with minimal hassle. Its oven includes baking and broiling elements that provide heat from both the top and bottom, allowing chefs to achieve restaurant-quality results right at home.

The JGB428 also highlights GE's commitment to energy efficiency, utilizing advanced technology to reduce power consumption while still delivering powerful cooking performance. With an intuitive digital display and straightforward controls, this model is designed for seamless user interaction, making it easier to set cooking times, temperatures, and select different cooking modes.

In summary, the GE 49-85179 and its counterparts—the JGB428SERSS and JGB428—are characterized by their smart design, advanced cooking technologies, and energy efficiency. Together, they represent a commitment to enhancing the culinary experience, providing home cooks with the tools they need to create delicious meals with confidence and ease. With these ranges, General Electric continues to innovate in the realm of home cooking appliances.
Top Page Image Contents