Maytag W10252706B installation instructions Complete Installation, To Replace

Page 13
To Replace:
When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician.

To Replace:

1.Lift up the back of the storage drawer and place it inside the range in its fully forward position.

2.Lift up the front of the storage drawer to a level position.

3.Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides.

A

A. Engage drawer glide.

4.Once the storage drawer is fully engaged on both sides, slide the drawer back into the closed position.

5.NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides.

Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check that the range is level. See “Level Range.”

5.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, read the “Range Care” section of the Use and Care Guide.

6.Read “Range Use” in the range Use and Care Guide.

7.Plug power cord into appropriate outlet. Turn power on.

8.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.

If range does not operate, check the following:

Household fuse is intact and tight; or circuit breaker has not tripped.

Range is plugged into an outlet.

Electrical supply is connected.

See “Troubleshooting” in the Use and Care Guide.

13

Image 13
Contents INSTALLATION INSTRUCTIONS 30 76 CM FREESTANDING ELECTRIC RANGES W10252706BTable of Contents Your safety and the safety of others are very important RANGE SAFETYDANGER Mobile Home - Additional Installation Requirements INSTALLATION REQUIREMENTSTools and Parts Location RequirementsCabinet Dimensions Product DimensionsElectrical Requirements - U.S.A. Only A C B D EIf connecting to a 3-wire system If connecting to a 4-wire systemElectrical Connection Install Anti-Tip Bracket INSTALLATION INSTRUCTIONSUnpack Range A D C BDirect Wire Power Supply CordElectrical Connection - U.S.A. Only Style 1 Power supply cord strain relief 4-wire connection Power Supply CordStyle 2 Direct wire strain relief connecting toA B C D 3-wire connection Power Supply CordE. Neutral center wire D. Neutral white wire4-wire Connection Direct Wire Direct Wire Installation Copper or Aluminum WireBare Wire Torque Specifications A B CDEA B CD E 3-wire connection Direct WireD. Bare green ground wire E. Neutral white wireLevel Range Verify Anti-Tip Bracket LocationStorage Drawer To RemoveTo Replace Complete InstallationFor direct-wired ranges For power supply cord-connected rangesMoving the Range Top edge Left edge ANTI-TIP BRACKET TEMPLATE2009 W10252706B9/09 All rights reserved