Bosch Appliances JBP80 owner manual Using the oven controls, Cleaning

Page 10

Operating Instructions Safety Instructions

Using the oven controls.

Throughout this manual, features and appearance may vary from your model.

Oven Control, Clock and Timer Features and Settings

and Cleaning

BAKE/TEMP RECALL Pad

Touch this pad to select the bake function.

BAKE Light

Flashes while in edit mode—you can change the oven temperature at this point. Glows when the oven is in bake mode.

START/ON Pad

Must be touched to start any cooking or cleaning function.

KITCHEN TIMER ON/OFF or TIMER ON/OFF Pad

Touch this pad to select the timer feature. Then press + and – pads to adjust time.

TIMER Light

Flashes while in edit mode—you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset.

Consumer Support Troubleshooting Tips Care

Display

Shows the time of day, oven temperature, whether the oven is in the bake, broil or self-cleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature.

If “F– and a number or letter” flash in the display and the oven control signals, this indicates a function error code.

If your oven was set for a timed oven operation and

a power outage occurred, the clock and all programmed functions must be reset.

The time of day will flash in the display when there has been a power outage. Reset the clock.

If the function error code appears during the self-cleaning cycle, check the oven door latch. The latch handle may have been moved, even if only slightly, from the latched position. Make sure the latch is moved to the right as far as it will go.

Touch the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. If the function error code repeats, disconnect the power to the range and call for service.

CLOCK Pad

To set the clock, press this pad twice and then press the + and – pads. The time of day will flash in the display when the oven is first turned on.

START TIME Pad

Use along with the COOKING TIME or SELF CLEAN pads to set the oven to start and stop automatically at a time you set.

START TIME Light

Flashes while in edit mode—you can change the start time at this point. Glows when the function has been activated.

COOKING TIME Pad

Touch this pad and then touch the + or – pads to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out.

COOKING TIME Light

Flashes while in edit mode—you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents RangesSelf-Cleaning Radiant Write the model and serial numbers here Model # Serial #Important Safety Notice All ranges can tip and injury could resultTroubleshooting Tips Consumer Support GEAppliances.comTroubleshooting Tips Care Cleaning Operating Instructions SafetyConsumer Support Radiant Surface Units Troubleshooting Tips Cleaning Operating InstructionsCare Instructions Care and Cleaning Using the surface unitsSafety Instructions OperatingConsumer Support Troubleshooting Tips Care Cleaning OperatingInstructions Troubleshooting Tips Consumer Support Selecting types of cookwareUsing the oven controls CleaningPower Outage Care and Cleaning Troubleshooting Tips Consumer SupportPower failure. Reset the clock Using the oven Broiling Guide How to Set the Oven for BroilingInstructions Operating Broiling GuideUsing the clock and timer How to Set an Immediate Start and Automatic Stop Using the timed baking and roasting featuresSafety Instructions How to Set a Delayed Start and Automatic StopSafety Instructions Special features of your oven controlHour Shut-Off How to Set for Regular Baking/Roasting Using the Sabbath FeatureDesigned for use on the Jewish Sabbath and Holidays How to Exit the Sabbath Feature To Adjust the ThermostatType of margarine will affect baking performance Before a Clean Cycle Using the self-cleaning ovenCare and Cleaning Troubleshooting Tips Consumer Support How to Set the Oven for CleaningHow to Delay the Start of Cleaning Consumer Support Troubleshooting TipsAfter a Clean Cycle Vinegar and water mixtureHow to Remove Packaging Tape Care and cleaning of the rangeSafety Instructions Operating Instructions Control KnobsPainted Surfaces Control PanelSafety Instructions Operating InstructionsOperating Instructions Safety Cleaning the glass cooktopConsumer Support Troubleshooting Tips Cooktop Seal Tips Consumer SupportMetal Marks and Scratches Damage from Sugary Spills and Melted PlasticBefore You Call For Service… Problem Possible Causes What To DoRemoval instructions in the Care and cleaning Clock and timer doSee the Using the clock and timer section Not workClean cycle During a clean cycleUnlock Oven not clean after Won’t closeOr letter flash Power outageA number DisplayAccessories Looking For Something More?Troubleshooting Tips Consumer Support GE Electric Range WarrantySafety Instructions Operating Instructions GE Will ProvideConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio
Top Page Image Contents