Bosch Appliances JBP80 A number, Or letter flash, Display goes blank, Display flashes, Vent

GEAppliances.com

Problem	Possible Causes	What To Do
“F— and a number	You have a function	• Press the CLEAR/OFF pad. Put the oven back into
or letter” flash	error code.	operation.
in the display
	If the function code repeats.	• Disconnect all power to the range for at least 30
		seconds and then reconnect power. If the function
		error code repeats, call for service.
		• On self-cleaning models, if a function error code
		appears during the self-cleaning cycle, check the oven
		door latch. The latch may have been moved, if only
		slightly, from the locked position. Make sure the latch
		is moved to the right as far as it will go. Press the
		CLEAR/OFF pad. Allow the oven to cool for one hour.
		Put the oven back into operation.
Display goes blank	A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
	blown or the circuit
	breaker tripped.
	The clock is turned off	• See the Using the clock and timer section.
	from showing in the display.
Display flashes	Power failure.	• Reset the clock.
Unable to get the	Oven control pads were	• The BAKE and BROIL HI/LO pads must be pressed
display to show “SF”	not pressed properly.	at the same time and held for 3 seconds.
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by pressing the CLEAR/OFF pad, setting the clock
		and resetting any cooking function.
“Burning” or “oily”	This is normal in a new	• To speed the process, set a self-clean cycle for a
odor emitting from	oven and will disappear	minimum of 3 hours. See the Using the self-
the vent	in time.	cleaning oven section.
Strong odor	An odor from the insulation	• This is temporary.
	around the inside of the
	oven is normal for the first
	few times the oven is used.

29

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support