Using the surface units. | GEAppliances.com |
Throughout this manual, features and appearance may vary from your model.
Safety
How to Set
Push the knob in and turn in either direction to the setting you want.
At both OFF and HI the control clicks into position. You may hear slight clicking sounds during cooking, indicating the control is keeping the power level you set.
Be sure you turn the control knob to
OFF when you finish cooking.
A HOT COOKTOP indicator light will glow when any radiant element is turned on, and will remain on until the surface is cooled to approximately 150°F.
Indicator light will:
■come on when the unit is turned on or hot to the touch.
■stay on even after the unit is turned off.
■glow until the unit is cooled to approximately 150°F.
Instructions Operating
Dual Surface Unit Control Knob
The right front surface unit has 2 cooking sizes to select from so you can match the size of the unit to the size of the cookware you are using.
To use the small
To use the large
Using the Warming Zone
Instructions Care and Cleaning
WARMER GUIDE
SETTING | FOOD |
(Low) | Bread/Pastries |
(Medium) | Chocolate/Butter |
(Medium) | Sauces, Stews, |
| Cream Soups |
(Medium) | Vegetables |
(High) | Soups (liquid) |
(High) | Tea or Coffee |
The Warmer Guide is for reference only and the SETTING that you need will depend on the amount and type of food, the starting temperature of the food and the length of the holding time.
The WARMING ZONE, located in the back center of the glass surface, will keep hot, cooked food at serving temperature.
Always start with hot food. Do not use to heat cold food. Placing uncooked or cold food on the WARMING ZONE could result in
Push and turn the control knob to any desired setting.
For best results, all foods on the WARMING ZONE should be covered with a lid or aluminum foil. When warming pastries or breads, the cover should be vented to allow moisture to escape.
Always use pot holders or oven mitts when removing food from the WARMING ZONE, since cookware and plates will be hot.
CAUTION: Do not warm food on the WARMING ZONE for more than two hours.
NOTE: The surface warmer will not glow red like the cooking elements.
A HOT surface indicator light will glow when the glass surface is hot and will remain on until the surface is cool enough to touch. Lower settings may not heat the glass surface enough to cause the HOT surface indicator light to come on.
A WARMING ZONE indicator light will glow when the unit is on.
■Do not use plastic wrap to cover food. Plastic may melt onto the surface and be very difficult to clean.
■Use only cookware recommended for
Troubleshooting Tips Consumer Support
7