Verona VECTGMS365SS, VECTGMS304SS manual Gas Requirement, Important Notes for Gas Connection

Page 10

Installation Manual

ENGLISH

Gas Requirement

A QUALIFIED SERVICE MAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION.

Leak testing of the appliance shall be conducted by the installer according to the instructions given.

WARNING

If the line pressure supplying the appliance pres- sure regulator exceeds 14 inches W.C. (any gas), an external regulator must be installed in the gas line ahead of the appliance regulator to reduce the pressure to no more than 14 inches W.C. Failure to do this can result in malfunction and damage to the appliance.

Important Notes for Gas Connection

The appliance and its individual gas shutoff valve must be disconnected from the gas supply piping sys- tem during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa).

All supply piping, except as noted, should use com- mon National Pipe Thread (N.P.T.). For all pipe con- nections use an approved pipe joint compound resis- tant to the action of LP gas.

This appliance is designed for use with NG gas or LP gas.

The gas pressure regulator is supplied with this appli- ance. It must be installed in the gas way ahead of the manifold entrance. It is pre-set for use with natural gas. To use it with different gas it must be converted, as described in the Gas conversion paragraph (see figure 17 and 18).

If at any time the appliance is to be used with a differ- ent type of gas, all the conversion adjustments must be made by a qualified technician before attempting to operate the cooktop on that gas.

The gas should be supplied to the appliances pres- sure regulator, at line pressure between 6 and 14 inches of water column for NG, and between 11 and 14 inches of water column for LP.

Important:

￿￿NEVER REUSE OLD CONNECTORS WHEN IN- STALLING THIS COOKTOP.

To reduce the likelihood of gas leaks, apply teflon tape or a thread compound approved for use with LP or Natural gases to all threaded connections.

Apply a non-corrosive leak detection fluid to all joints and fittings in the gas connection between the supply line shut-off valve and the cooktop inlet.

Check for leaks!

Bubbles appearing around fittings and connec- tions will indicate a leak. If a leak appears, turn off supply line gas shut-off valve, tighten connections, turn on the supply line gas shutoff valve, and re- test for leaks. Never test for gas leaks with an open flame.

￿￿NEVER TIGHTEN TO MORE THAN 35 ft lbs OF TORQUE.

10

Image 10
Contents VECTGMS365SS VECTGMS304SS Page Installation Manual Please read all instructions before using this appliance Before Starting InstallationCooktop Installed over Oven Installation Special WarningsProduct Dimensions and Cutout Requirements Important Preparation SuggestionsHole 1-1/5 3 cm Cutout requirementsThis cooktop has been designed with wide toler Mobile Home InstallationDards, Title 24 CFR, Part 3280 formerly the Federal Excessive Weight Hazard Cooktop InstallationCut Hazard Do not Over Tighten Important Notes for Gas Connection Gas RequirementNever Tighten to More than 35 ft lbs of Torque Gas Connection Threads of the Gas Manifold with gasket suppliedConducted by the Installer according to NECTION. Leak testing of the appliance shall beStructions given Pressure Testing Pressure Test MethodElectrical Connection Electrical RequirementsGeneral Information Electrical RequirementsWiring diagram 30 wide Replace injectors on two rings flame burner Conversion for LP or NG GasConverting Appliance for Use with LP Gas Replace injector on one ring flame burnersConverting Appliances for Use with NG Gas Pressure regulator conversionInjectors position One ring flame burners Dual flame ringAdjustment for Burners with one or two rings Flame Low Flame AdjustmentCounterclockwise to increase Electric gas ignition Burner FlamesRencontrerez dans ce manuel ’installateurTables des matieres Au clientAvertissement Spéciaux Avant de Procéder à l’InstallationInstallation de la Table de Cuisson Au-Dessus du Four Que faire si vous sentez une odeur de gazDimensions et Dispositions pour la Découpe Suggestions Importantes de PréparationDiamètre du trou 1-1/5’’ 3 cm Dispositions pour la découpeInstallation autocaravane Risque du fait du poids excessif Installation de la Table de CuissonRisque de coupure Bien Serrer Mais PAS Trop Fort Conditions Requires Gaz NE Jamais Serrer À Plus DE 35 ft Ibs pieds livre DE TorsionRaccordement du Gaz Tructions données Vérification de la Pression Méthode de Test de PressionBranchement Electrique Conditions Requises ElectricitéInformation Général Requises ElectricitéSchéma électrique largeur Remplacez un injecteur brûleur avec deux anneaux de flamme Conversion Gaz PL ou Gaz NaturelConversion de l’Appareil pour Fonctionner au Gaz PL Remplacez un injecteur Brûleurs avec un anneau de flammeConversion du régulateur de pression Régulateur de pressionConversion PL Position des InjecteursRéglage Petite Flamme Réglage pour brûleurs avec un ou deux anneaux de flammeAllumage à gaz électrique Les Flammes du BrûleurLEA Y Conserve Estas INSTRUCCIONES. Instalador Tabela de ContenidoPagina ClienteQué hacer si detecta olor a gas Advertencias EspecialesAntes de comenzar la instalación Instalación de la placa sobre un hornoDimensiones del Producto y de Encastre Importantes Consejos de PreparaciónDiámetro orificio 1-1/5’’ 3 cm NotaInstalación en Casas Móviles Peso excesivo Instalación de la Placa de CocciónPeligro de corte Figura Paso Observaciones importantes para la conexión del gas Conexión del Gas RequisitosNunca Apriete a MÁS DE 35 pies-libras DE Torque Conexión del Gas FiguraCabo por el instalador, que tendrá que seguir las COS DE GAS. La prueba de fugas debe ser llevadaInstrucciones suministradas Prueba de Presión Método de la prueba de presiónConexión Eléctrica Requisitos Conexión Eléctrica RequisitosConexión Eléctrica Peligro de descarga eléctricaFigura 15. Diagrama eléctrico ancho Conversión del Electrodoméstico para su Uso con Gas LP Conversión a Gas LP o NGSustitución del inyector una sola corona Conversión del Regulador de Presión Figura 20. Regulador de presiónConversión LP Posición de los InyectoresGraduación de la Llama Baja Figura 21. Graduación de la llamaDelgada introducido en la cavidad correspondiente al Ignición eléctrica del gasLas llamas del quemador Centro del vástago hasta apretar a fondo la válvulaPage Page Page EuroChef USA, Inc
Related manuals
Manual 40 pages 17.75 Kb

VECTGMS304SS, VECTGMS365SS specifications

The Verona VECTGMS365SS and VECTGMS304SS represent the pinnacle of modern kitchen technology, seamlessly merging functionality with culinary artistry. Both models from Verona’s extensive range of kitchen appliances offer features designed for both the home chef and the kitchen enthusiast.

The Verona VECTGMS365SS is a robust gas range that boasts a 36-inch width, featuring a total of five sealed burners. This model's powerful burners provide a customizable cooking experience, allowing users to select the perfect flame for simmering sauces or achieving a high-heat sear on meats. With an impressive total output of 18,000 BTUs on its two high-powered burners, the VECTGMS365SS offers remarkable control over temperature. An additional advantage of this range is its spacious oven, which has a capacity of 5.2 cubic feet, providing ample space for cooking large meals.

In addition to sheer power, this model incorporates advanced technologies such as infrared broiling, which enables even heating and precision cooking. The continuous cast-iron grates ensure that pots and pans easily slide from burners to the oven, minimizing disruptions during cooking. The range is designed with a modern aesthetic, featuring a stainless steel finish that not only enhances its durability but also adds a contemporary touch to any kitchen.

On the other hand, the Verona VECTGMS304SS offers a slightly smaller footprint at 30 inches, yet it retains powerful and versatile cooking capabilities. It also features four sealed burners, with a maximum output of 15,000 BTUs, suitable for a variety of cooking techniques. The oven capacity is slightly smaller at 4.5 cubic feet, but it is still spacious enough for everyday cooking needs.

Both models are equipped with user-friendly electronic ignition systems, meaning they ignite quickly and safely. They also come with an oven light and multiple cooking modes, including bake, broil, and convection settings, ensuring fluffy pastries and perfectly roasted meats.

Overall, the Verona VECTGMS365SS and VECTGMS304SS exemplify the perfect marriage of performance and style in kitchen ranges. With exceptional heating power, precision technology, and sleek designs, they cater to the diverse needs of modern kitchens, making them an excellent choice for anyone looking to elevate their cooking experience. Whether for family dinners or entertaining guests, these ranges ensure that meals can be prepared with both ease and sophistication.