Southbend SEZ-3, SEZ-5 Electric Requirements, Water Requirements, Drain Requirements, Controls

Page 5

SEZ SERIES COUNTERTOP STEAMERS

SPECIFICATIONS

ELECTRIC REQUIREMENTS

One electric connection is required to the fuse block of the steamer. All units shipped per customer order, three phase or single phase (a kit is available for field conversion to three phase or single phase). Circuit must be wired for the maximum amps at required voltage.

Voltage

 

Total Connected Amps

 

Model SEZ-3

Model SEZ-5

 

1 Phase

3 Phase

1 Phase

3 Phase

208 V

44

25

57

33

220 V

41

24

54

31

240 V

38

22

49

29

480 V

19

11

25

15

WATER REQUIREMENTS

To meet warranty requirements, the water supply must be as follows:

Connection

1/4" NPT (female)

 

cold water

Pressure

30 to 60 PSI

 

 

Total Dissolved Solids (TDS)

60 PPM

 

 

Hardness

2 grains or 35 PPM

 

 

pH

7.0 to 7.5

Typical usage is 0.02 gpm. Maximum instantaneous usage is 0.12 gpm.

In order to minimize service problems and to meet the warranty requirements, a water treatment system (softener) is recommended when water quality does not meet the limits stated above.

DRAIN REQUIREMENTS

The drain outlet has a 3/8" NPT (male) connector. DO NOT directly connect the drain to a plumbing system unless you also install an “open funnel” downstream of this connection. There must be no back-flow or back- pressure into the drain connection!

CONSTRUCTION SPECIFICATIONS

Exterior: Type 304 stainless steel with #3 sanitary finish.

Interior: #304 stainless steel.

Power Source: One electric power source for controls and heating elements, as well as one ground wire. A positive ground connection is essential.

Cooking Compartment: Fully insulated.

CONTROLS

ON/OFF Lever: In the “OFF” position, the power is off and the drain valve is open. In the “ON” position, the power is on and the drain valve is closed.

60 Minute Timer: Time can be set between 1 and 60 minutes. When time expires, buzzer sounds. Buzzer can be disabled by turning the knob to manual position. Timer has no effect on the operation of the steamer.

“SERVICE REQUEST” Light: Unit signals when service is needed.

“ON” Light: Indicates power is on.

OPERATORS MANUAL 1181587

PAGE 5

SPECIFICATIONS

Image 5
Contents Super Simple Steam SEZ Series Countertop Steamers Safety Precautions Table of Contents Dimensions SpecificationsElectric Requirements Construction SpecificationsWater Requirements Drain RequirementsUnpacking InstallationInstallation Bottom View Electric Connection Water Connection Drain Connection Startup OperationOperation ShutdownSuggested Cooking Times Cooking HintsCooking Tips Cooking Hints SEZ Series Countertop Steamers Periodic Cleaning CleaningDaily Cleaning Semiannual Cleaning Troubleshooting Figures and Procedures TroubleshootingTroubleshooting KEY Unit Not Heating Up, on Light Not Lit Disconnect Power AT Circuit BreakerTroubleshooting Excessive Steam Coming from Pressure Relief Vent Remove control panel, but leave plugged Service Request Light Comes On During OperationBuzzer Does Not Come On Voltage Check at Control Panel Fuse Block Disconnect Power AT Circuit BreakerHeating Element Resistance Check at Contactor Do not Remove Heating Element Lead Wires for this TestMain Fuse Replacement Power Switch Continuity Check Contactor and MOV Check Timer and Buzzer Check Door Switch Continuity Check Float Switch Continuity Check Controller Check Inlet Float Valve Check Pressure Switch Check High-Limit Thermostats Check Electric Schematic for 208, 220, and 240 Volt Model SEZ-3 Electric Schematic for 480 Volt Model SEZ-3 Electric Schematic for 208, 220, and 240 Volt Model SEZ-5 Electric Schematic for 480 Volt Model SEZ-5 Parts Index of Parts DiagramsCavity and Heater Parts Control Panel Parts Rear View See parts list on previous Control Panel Parts Front and Isometric Views Water Inlet and Drain Parts Door Assembly Parts Float Tank Parts Super Simple Steam SEZ Series Countertop Steamers

SEZ-3, SEZ-5 specifications

The Southbend SEZ-5 and SEZ-3 are prominent models from Southbend's line of commercial cooking equipment, renowned for their robust construction and high-performance capabilities. These ranges are designed to meet the demands of busy kitchens, such as those found in restaurants, hotels, and catering companies, providing chefs with reliable tools to prepare meals efficiently.

One of the main features of the SEZ-5 is its versatile cooking options. It typically includes a combination of open burners, griddles, and ovens, allowing chefs to execute a wide range of cooking techniques. The SEZ-3, while slightly smaller, offers similar functionality tailored for establishments with space constraints but still requiring high output. Both models are equipped with intuitive controls, enabling precise temperature adjustments to ensure optimal cooking conditions.

The construction of both the SEZ-5 and SEZ-3 is noteworthy. Made from high-quality stainless steel, these ranges are designed to withstand the rigors of a commercial kitchen while ensuring easy cleaning and maintenance. The robust build not only enhances durability but also provides excellent heat retention and distribution. This is crucial for achieving consistent cooking results.

In addition, Southbend has integrated advanced technologies into these models, such as electronic ignition for increased operational convenience and safety. The SEZ-5 and SEZ-3 also come with heavy-duty cast iron grates, which provide superior heat retention and support for heavy pots and pans. This ensures that chefs can cook with maximum efficiency and confidence, even during peak times.

Another defining characteristic is the inclusion of an easy-to-read, ergonomic control panel that simplifies the management of cooking parameters. The presence of built-in safety features, including flame failure devices, further enhances the overall functionality and safety of these ranges.

Moreover, the SEZ series is designed with flexibility in mind, offering options for configurations according to individual kitchen layouts. Whether you need a standard configuration or a customized solution, Southbend provides options to suit diverse cooking environments.

In summary, the Southbend SEZ-5 and SEZ-3 are exceptional choices for commercial kitchens, defined by their versatile cooking functions, robust construction, innovative technologies, and user-friendly design. Chefs who utilize these ranges can expect enhanced performance and reliability, ensuring that they meet the high demands of their culinary operations.