Brinkmann 816-3500 SERIES, 815-3500 owner manual Hose And Regulator

Page 7
HOSE AND REGULATOR:

HOSE AND REGULATOR:

Your fryer is equipped with a Type 1 connection device with the following features:

1.The system will not allow gas flow from the cylinder until a positive connection to the valve has been made.

NOTE: The cylinder valve must be turned off before any connection is made or removed.

2. A thermal device that will shut off the gas flow if the device is subject to temperatures above 240°F to 300°F (115°C to 150°C). If this should happen, remove the entire regulator assembly and dispose of properly. A replacement regulator assembly can be purchased by contacting Brinkmann at

1-800-527-0717. The cause of the excessive heat should be determined and corrected before using your fryer again.

3.A flow limiting device, when activated, restricts the flow of gas to 10 cubic feet per hour.

Manual backgroundWARNING

Never use your fryer without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

Manual backgroundWARNING

The pressure regulator and hose assembly supplied with your gas fryer is designed to work with an LP gas supply cylinder.

DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

DO NOT use any other pressure regulator/hose assembly other than the one supplied with your fryer.

DO NOT attempt to adjust or repair the regulator. A replacement regulator can be supplied by contacting Brinkmann. The regulator is designed to operate at a maximum output pressure of 10 psi ( pounds/square inch).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your fryer. Only the Brinkmann supplied replacement should be used.

6

Image 7
Contents KEEP THIS MANUAL FOR FUTURE REFERENCE ASSEMBLY AND OPERATING INSTRUCTIONSREAD THIS MANUAL This appliance can produce carbon monoxide which has no odor DANGERUsing it in an enclosed space can kill you CARBON MONOXIDE HAZARDDo NOT install or use in or on recreational vehicles and/or boats Do NOT use lid when heating or cooking with oilDO NOT use external electrical sources with this appliance CYLINDER SPECIFICATIONS INSTALLATION INFORMATIONFILLING THE LP GAS CYLINDER HOSE AND REGULATOR LEAK TESTING CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDERWHEN TO PERFORM A LEAK TEST C Back side of connection nut to brass nipple GAS LEAK TESTINGF Gas supply hose connection to burner assembly A Supply tank cylinder weld B Connection nut to cylinder valve12 ft PRE-START CHECK LISTLIGHTING INSTRUCTIONS 10 ft2” 1” 0” HOW TO REIGNITE BURNERBURNER FLAME CHECK TURNING OFF THE FRYERFor Use With Cooking Vessels That Do Not Have Maximum Fill Line HOW TO DETERMINE PROPER AMOUNT OF OILOPERATING INSTRUCTIONS Pan & Basket Turkey Stand7” Strainer 14” StrainerCLEANING & GENERAL MAINTENANCE BURNER ASSEMBLY/MAINTENANCENOTE Wear eye protection when cleaning burner Proof of purchase will be required ASSEMBLY INSTRUCTIONSFOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT PROCEED TO “GAS LEAK TESTING” SECTION ON PAGEONE YEAR LIMITED WARRANTY 90 DAY LIMITED WARRANTY2003 The Brinkmann Corporation Dallas, Texas 75244 U.S.A