SAFETY
FORYOUR SAFETY AND SAFETY OF OTHERS!
Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the Safety Messages and Operating Instructions could result in injury to yourself and others.
This manual has been developed to provide complete instructions for the safe and efficient operation of this equipment. Refer to the engine manufacturer's instructions for data relative to its safe operation.
Before using this equipment ensure that the operating individual has read and understood all instructions in this manual.
SAFETY MESSAGE ALERT SYMBOLS
The three Safety Messages shown below will inform you about potential hazards that could injure you or others. The Safety Messages specifically address the level of exposure to the operator, and are preceded by one of three words: DANGER,WARNING, or CAUTION.
DANGER
You WILL be KILLED or SERIOUSLY INJURED if you DO NOT follow these directions.
WARNING
You CAN be KILLED or SERIOUSLY INJURED if you DO NOT follow these directions.
CAUTION
You CAN be INJURED if you DO NOT follow these directions.
HAZARD SYMBOLS
Potential hazards associated with the operation of this equipment will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols.
WARNING — Lethal Exhaust Gas Hazards
Engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled. NEVER operate this equipment in a confined area or enclosed structure that does not provide ample free flow air.
WARNING — Explosive Fuel Hazards
Fuel is extremely flammable and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids.
DO NOT fill the fuel tank while the engine is running or hot. DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in
WARNING — Burn Hazards
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operation. Never operate the engine with heat shields or heat guards removed.
WARNING — Respiratory Hazards
ALWAYS wear approved respiratory protection when required.
PAGE 6 — MS120 HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #0 (07/10/08)