Multiquip MVC-82VHW manual Inspection, Before Starting, Engine OIL Check, Fuel Check

Page 16

INSPECTION

BEFORE STARTING

1.Read safety instructions at the beginning of manual.

2.Clean the compactor, removing dirt and dust, particularly the engine cooling air inlet, carburetor and air cleaner.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check carburetor for external dirt and dust. Clean with dry compressed air.

5.Check fastening nuts and bolts for tightness.Loosened screws or bolts due to vibration, could lead to unexpected accident.

ENGINE OIL CHECK

1.To check the engine oil level, place the pump on secure level ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 3) and wipe clean.

Figure 3. Engine Oil Dipstick (Removal)

3.Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 4), fill to the edge of the oil filler hole with the recommended oil type (Table 4). Maximum oil capacity is 0.63 quarts (0.60 liters).

Figure 4. Engine Oil Dipstick (Oil Level)

The Oil Alert System will automatically stop the engine before the engine falls below safe limits.Always be sure to check the engine oil level prior to starting the engine.

Table 4. Oil Type

Season

Temperature

Oil Type

 

 

 

Summer

25°C or Higher

SAE 10W-30

 

 

 

Spring/Fall

25°C~10°C

SAE 10W-30/20

 

 

 

Winter

0°C or Lower

SAE 10W-10

 

 

 

DANGER — Explosive Fuel Hazard

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has

been completely wiped up, and the area surrounding the engine is dry.

FUEL CHECK

1.Remove the gasoline cap located on top of fuel tank.

2.Visually inspect to see if the fuel level is low. If fuel is low, replenish with unleaded fuel.

3.When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately!

PAGE 16 — MVC-82VH/VHW PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #1 (04/25/08)

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Model MVC-82VH/VHW Proposition 65 Warning MVC-82VH/VHW Operation and Parts Manual REV. #1 04/25/08 Table of Contents MVC-82VH/VHW Plate CompactorParts Ordering Procedures Ordering parts has never been easierSafety Safety Message Alert SymbolsSafety General Safety Rules and RegulationsMaintenance Safety Loading and UnloadingTransporting RefuelingBattery Safety for Electric Start EmergenciesSpecifications Specifications CompactorDimensions DimensionsGeneral Information Components Compactor Water Tank MVC-82VHW onlyComponents Engine Engine ComponentsInspection Before StartingEngine OIL Check Fuel CheckBelt Check Vibrator OIL CheckOperation Initial START-UPOperation Stopping the EngineMaintenance Inspection and MaintenanceEngine OIL Daily ServiceAIR Filter Changing Vibrator OIL Spark PlugPlate Compactor Storage Troubleshooting Engine TroubleshootingEngine Troubleshooting MVC-82VH/VHW Operation and Parts Manual REV. #1 04/25/08 Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts MVC-80VH/VHWCOMPACTOR with Honda GX160U1SM12 EngineNameplate and Decals Honda GX160U1SM12Part Name QTY Remarks DECAL, MQ MarkBody Assy Earth Wire Shock Absorber D45H41NUT M10 WASHER, Lock M10Vibrator Assy Vibrating Case WASHER, Lock M14WASHER, Flat M14 Case COVER/PULLEYWater Tank ASSY. MVC82VHW only Guard Hook CAP, Water Tank NBRWasher 10.5X21X2 SUS Nylon NUT M10 SUSHonda GX160U1SM12 Engine Cylinder Head Assy CLIP, Valve Guide GASKET, Cylinder HeadCOVER, Head TUBE, BreatherHonda GX160U1SM12 Engine Cylinder Barrel Assy Switch ASSY., OIL Level Governor AssySLIDER, Governor SHAFT, Governor ARMHonda GX160U1SM12 Engine Crankcase Cover Assy GASKET, Crankcase GASKET, OIL Filler CAPHonda GX160U1SM12 Engine Crankshaft Assy Crankshaft Honda GX160U1SM12 Engine PISTON/RINGS Assy BOLT, Connecting ROD Ring SET, Piston STDPiston STD PIN, PistonHonda GX160U1SM12 Engine Camshaft Assy SPRING, Weight Return SEAL, Valve StemROD, Push ARM, Valve RockerHonda GX160U1SM12 Engine Recoil Starter Assy CASE, Recoil Starter REEL, Recoil StarterRATCHET, Starter PLATE, FrictionHonda GX160U1SM12 Engine FAN Cover Assy COVER, FAN Black PLATE, Side OIL AlertShroud Alert UNIT, OILHonda GX160U1SM12 Engine Carburetor Assy PLATE, Lever Setting Gasket SETValve SET, Float Float SETHonda GX160U1SM12 Engine AIR Cleaner Assy COVER, AIR Cleaner GROMMET, AIR CleanerCOLLAR, AIR Cleaner Collar B, AIR CleanerHonda GX160U1SM12 Engine Muffler Assy Muffler PROTECTOR, MufflerPROTECTOR, Lower Deflector CPHonda GX160U1SM12 Engine Fuel Tank Assy JOINT, Fuel Tank TANK, Fuel BlackFILTER, Fuel NUT, Flange 6MMHONDAGX160U1SM12ENGINE-COOLINGFAN&FLYWHEELASSY FAN, Cooling PULLEY, StarterFlywheel NUT, Special 14MMHonda GX160U1SM12 Engine Ignition Coil Assy Coil ASSY., Ignition CAP AssyHonda GX160U1SM12 Engine Control Assy HOLDER, Wire ARM, GovernorROD, Governor SPRING, GovernorHonda GX160U1SM12 Engine Labels Assy MARK, Choke Gray Terms and Conditions of Sale Parts Freight PolicyMVC-82VH/VHW Operation and Parts Manual REV. #1 04/25/08 HERE’S HOW to GET Help

MVC-82VH, MVC-82VHW specifications

The Multiquip MVC-82VHW and MVC-82VH are advanced walk-behind vibratory plate compactors, designed for efficient soil compaction in various construction and landscaping applications. These models combine robust engineering with cutting-edge technologies, making them ideal for both professionals and contractors.

The MVC-82VHW is powered by a reliable Honda GX160 engine, delivering impressive performance with minimal vibration. This model stands out due to its built-in water tank system, which allows for the effective compaction of asphalt while reducing the risk of material sticking to the base plate. Furthermore, the MVC-82VHW features an easy-to-use hand throttle, allowing operators to adjust the engine speed on the fly to suit specific job requirements.

On the other hand, the MVC-82VH is equipped with a durable Robin Subaru engine, known for its impressive torque and fuel efficiency. Both models feature a heavy-duty, high-quality steel frame that is designed to withstand the rigors of daily use on tough job sites. Their compact design allows for easy transportation and maneuverability, even in confined spaces.

A key characteristic of both models is their high-frequency vibration technology. This feature ensures optimal compaction in a variety of soil types, from granular to cohesive materials. The MVC-82s provide an operating frequency that allows them to achieve excellent compaction depth, making them a valuable asset for construction sites, road repairs, and landscaping tasks.

User comfort is also a significant consideration in the design of the MVC-82 series. The machines are outfitted with padded handles, which reduce operator fatigue during prolonged use. Additionally, the low center of gravity design enhances stability and control, allowing operators to handle challenging terrains with confidence.

In summary, the Multiquip MVC-82VHW and MVC-82VH compactors are exceptional machines that deliver superior performance and durability. With powerful engines, high-frequency vibration technology, and user-centric design features, these models are ideal for maximizing efficiency in compaction tasks across various job sites. They represent an investment in quality and reliability, setting a standard in the compacting equipment market. Whether for asphalt or soil compaction, these machines make the job easier and more efficient.
Top Page Image Contents