Multiquip MVC-70H/HW Maintenance, Inspection and Maintenance ServiceTables, Daily Service

CAUTION - Inspection

Inspection and other services should always be carried out on hard and level ground with the engine shut down.

Inspection and Maintenance ServiceTables.

1.To make sure your plate compactor is always in good working condition before using, carry out the maintenance inspection in accordance with Tables 5 through 7.

MVC-70H/HW — MAINTENANCE

CAUTION - Inspection Intervals

These inspection intervals are for operation under normal conditions. Adjust your inspection intervals based on the number of hours plate compactor is in use, and particular working conditions.

CAUTION - Inspection Intervals

Fuel piping and connections should be replaced every 2 years.

TABLE 5. MVH-64H MACHINE INSPECTION

ITEM	HOURS OF	REMARKS
	OPERATION
Damaged Parts	Every 8 hours
	(every day)
Loose or Lost Screws	Every 8 hours
	(every day)
Function of Controlling	Every 8 hours
System Part	(every day)
Vibrator Oil Check	Every 100 hours	See page 16
Vibrator Oil	Every 300 hours	See page 22
Replacement
V-belt (clutch) Check	Every 200 hours	See page 17

TABLE 6. ENGINE CHECK

(For details, see separate Engine Manual)

Item	Hours of Operation
Leakage of oil or fuel	Every 8 hours (every day)
Tightness of fastening threads	Every 8 hours (every day)
	Every 8 hours (every
Engine oil check and replenishment	day)(Replenish to specified max.
	level)
Engine oil replenishment	At first 20 hours, then every 100
	hours
Air cleaner cleaning	Every 50 hours

Daily Service

zCheck for leakage of fuel or oil.

zRemove soil and clean the bottom of compaction plate.

zCheck engine oil, see page 16.

zCheck for loose screws including tightness. See Table 7 below (tightening torque ), for retightening:

TABLE 7.

TIGHTENING TORQUE (in. kg/cm) Diameter

Material	6mm	8mm	10mm	12mm	14mm	16mm	18mm	20mm
4T	70	150	300	500	750	1,100	1,400	2,000
6-8T	100	250	500	800	1,300	2,000	2,700	3,800
11T	150	400	800	1,200	2,000	2,900	4,200	5,600

*100 (6mm) 300 ~ 350 (8mm) 650 ~ 700 (10mm)

*(In case counter-part is of aluminum)

(Threads in use with this machine are all right handed)

Material and quality of material is marked on each bolt, and screw.

Engine Oil Replacement:

1.Replace engine oil, in first 20 hours of operation and every 100 hours afterwards.

2.Oil may be drained more easily when it is warm after operation (For more details, see separate HONDA Owner's Manual).

3.When changing the engine oil, the old oil can be drained by removing the oil filler cap, and unscrewing the engine oil drain plug located at the base of the engine (Figure 16).

4.Remember to refill engine crankcase with the recommended type of oil as listed in Table 4.

PAGE 20 — MVC-70H/HW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (11/02/05)