Rotel owner manual RSX-1550 Surround Sound Receiver

50 RSX-1550 Surround Sound Receiver

Note: Changing the default TUNER SETTING or REDIRECT SETTING can only be done at the same time as restoring the FACTORY DEFAULT settings. Therefore, we recommend selecting your default TUNER and REDIRECT settings and resetting to the FACTORY DEFAULT settings as the first step in configuring the unit, before you change or memorize any other configuration settings.

To restore the FACTORY DEFAULT settings: Place the highlight on the FACTORY DEFAULT line using the UP/DOWN buttons and use the +/– buttons to change the setting to YES. Press the ENTER button to proceed with resetting the FACTORY DEFAULT settings with re- confirmation screen. The unit will power off (to Standby Mode) and then on, with the factory settings restored. To return to the MAIN menu without resetting the FACTORY DEFAULT settings, change the entry to NO and press the ENTER button.

Note: Resetting to factory default settings will erase all stored settings including delay settings, speaker settings, balance settings, input settings and more. You will lose ALL system configuration settings. Be certain that you wish to do so before resetting the factory defaults.

To memorize USER DEFAULT settings: Many of the current configuration settings can be stored as a USER DEFAULT, which can be activated at any time from this menu screen.To save the current settings as a USER DEFAULT:

1.Place the highlight on the SET USER DEFAULT line using the UP/ DOWN buttons and use the +/– buttons to change the setting to YES.

2.Press the ENTER button to go to confirmation screen where a password must be entered. The default password is 8888. If the entered password is correct, the current settings will be saved as the new USER DEFAULT settings.

3.To return to the MAIN menu without saving changes, change all entries on the screen to NO and press ENTER.

Note: If there is insufficient memory to store a USER DEFAULT configuration file, the SET USER DEFAULT option will not be available.

To activate memorized USER DEFAULT settings: After you have stored a USER DEFAULT configuration file, you can activate those settings at any time by placing the highlight on the USER DEFAULT line using the UP/DOWN buttons. Use the +/– buttons to change the setting to YES. Press the ENTER button to proceed with activating the USER DEFAULT settings. To return to the MAIN menu without activating the USER DEFAULT settings, change the entry to NO and press the ENTER button.

To return to the MAIN menu without activating the USER DEFAULT settings, change the entry to NO and press the ENTER button.

To change the password: The password programmed at the factory is

0000. If you wish to change the password:

1.Place the highlight on the SET NEW PASSWORD line using the UP/ DOWN buttons. Use the +/– buttons to change the setting to YES. Press the ENTER button to proceed to the PASSWORD screen.

2.Enter the four digits of the old password by pressing the +/– buttons to select the first letter of the new password, then pressing ENTER to move to the second character. Repeat until the old password is entered. Successful entry of the old password will jump to the ENTER NEW PASSWORD line.

3.Enter the four digits of the new password by pressing the +/– buttons to select the first letter of the new password, then pressing ENTER

to move to the second character. Repeat until the new password is entered.

4.You will be asked to re-enter the password again on the CONFIRM PASSWORD line, following the same procedure. Once the password is successfully confirmed, it will be saved and you will return to the DEFAULT SETUP MENU automatically.

5To exit the PASSWORD screen without changing the password, highlight the DEFAULT SETUP MENU line and press ENTER to return to the previous screen.

Note: The factory password is 0000. A default password that will always be recognized is 8888.

RSX-1550 English v2.indd 50

27/8/08 14:22:29