SPECIAL CORD SET INSTRUCTIONS
1.A short power supply cord is provided to reduce the hazards resulting from becoming entangled in or tripping over a longer cord.
2.An extension cord may be purchased and used if care is exercised in its use.
3.If an extension cord is used, the marked electrical rating of the extension cord must be at least 10 amps and 120 volts. The resulting extended cord must be arranged so that it will not drape over the counter top or table top where it can be pulled on by children or tripped over accidentally.
•This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outbt, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
CAUTION: PRESSURE
In order to avoid possible burns to body parts and/or other Injury from hot steam and water NEVER open the boiler cap while your Mr. Coffee Steam Espresso/Cappuccino Maker is turned on or as long as there is pressure In the water tank.
In order to check if the machine is under pressure, proceed as follows:
1.Turn the selector control knob to OFF, and unplug the machine.
2.Rotate the selector control knob to the “steam” position. If steam comes out of the frothing tube, then the water tank is still under pressure. Turn the selector control knob to OFF.
3.To release the pressure, hold a pitcher with water under the frothing tube and immerse the frothing aid in the water. Slowly m Q.Q S.&&C control k!uhfna!!i!‘steam”oositiondreleasetisteam.
4.When the frothing tube stops releasing steam, the boiler cap can be removed.
5.Turn the selector control knob back to the OFF position.
6.Do not remove the filter holder at any time during the brewing process or until pressure is relieved.
7.Use caution when removing the filter holder from the brew head. The metal parts may still he very hot. Also, there may be hot water floating on the top of the filter basket
8.If the filter hdder is blocked, allow the machine to cool down, then release the steam with the instructions above. The blockage may be caused by too finely ground coffee. See “Problems and Causes” on page 11.
9.WHEN CLEANING THE FROTHING NOZZLE: Place a frothing pitcher or large cup (with at least an 11 ounce capacity) half full of water under the frothing aid. Make sure the tip of the frothing tube is submerged in liquid before turning the selector control knob to the “steam” position