Monessen Hearth VFCS20DNV, VFCS30DNV, VFCS30DPV, VFCS20DPV Carbon Monoxide Detector Requirements

Page 31

Massachusetts Residents Only — Please read and follow these special requirements

NOTE REGARDING VENTED PRODUCTS

This product must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts.

Any residence with a direct vent product must have a CO detector installed in the residence.

Installation of the fireplace or vented gas log in the State of Massachusetts requires the damper to be permanently removed or welded in the fully open position.

In addition, a naturally vented gas log may not be installed in a bedroom or bathroom in the State of Massachusetts.

Flex line installation must not exceed 36 inches and must have a T shutoff valve.

NOTE REGARDING VENT FREE PRODUCTS

This product must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts.

In addition, vent free products may not be installed in a bedroom or bathroom regardless of size or type in the State of Massachusetts.

Flex line installation must not exceed 36 inches and must have a T shutoff valve.

CARBON MONOXIDE DETECTOR REQUIREMENTS

(2)Revise 10.8.3 by adding the following additional requirements:

(a)For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust vent termination is less than seven (7) feet above finished grade in the area of the venting, including but not limited to decks and porches, the following requirements shall be satisfied:

1.Installation of carbon monoxide detectors. At the time of installation of the side wall horizontal vented gas fueled equipment, the installing plumber or gas fitter shall observe that a hard wired carbon monoxide detector with an alarm and battery back-up is installed on the floor level where the gas equipment is to be installed. In addition, the installing plumber or gas fitter shall observe that a battery operated or hard wired carbon monoxide detector with an alarm is installed on each additional level of the dwelling, building or structure served by the side wall horizontal vented gas fueled equipment. It shall be the responsibility of the property owner to secure the services of qualified licensed professionals for the installation of hard wired carbon monoxide detectors

a.In the event that the side wall horizontally vented gas fueled equipment is installed in a crawl space or an attic, the hard wired carbon monoxide detector with alarm and battery back-up may be installed on the next adjacent floor level.

b.In the event that the requirements of this subdivision can not be met at the time of completion of installation, the owner shall have a period of thirty (30) days to comply with the above requirements; provided, however, that during said thirty (30) day period, a battery operated carbon monoxide detector with an alarm shall be installed.

2.Approved Carbon Monoxide Detectors. Each carbon monoxide detector as required in accordance with the above provisions shall comply with NFPA 720 and be ANSI/UL 2034 listed and IAS certified.

3.Signage. A metal or plastic identification plate shall be permanently mounted to the exterior of the building at a minimum height of eight (8) feet above grade directly in line with the exhaust vent terminal for the horizontally vented gas fueled heating appliance or equipment. The sign shall read, in print size no less than one-half (1/2) inch in size, “GAS VENT DIRECTLY BELOW. KEEP CLEAR OF ALL OBSTRUCTIONS.”

4.Inspection. The state or local gas inspector of the side wall horizontally vented gas fueled equipment shall not approve the installation unless, upon inspection, the inspector observes carbon monoxide detectors and signage installed in accordance with the provisions of 248 CMR 5.08(2)(a)1 through 4.

(b)Exemptions: The following equipment is exempt from 248 CMR 5.08(2)(a)1 through 4:

1.The equipment listed in Chapter 10 entitled "Equipment Not Required To Be Vented" in the most current edition of NFPA 54 as adopted by the Board; and

2.Product Approved side wall horizontally vented gas fueled equipment installed in a room or structure separate from the dwelling, building or structure used in whole or in part for residential purposes.

(c)Manufacturer requirements — Gas Equipment Venting System Provided. When the manufacturer of Product Approved side wall horizontally vented gas equipment provides a venting system design or venting system components with the equipment, the instructions provided by the manufacturer for installation of the equipment and the venting system shall include:

1.Detailed instructions for the installation of the venting system design or the venting system components; and

2.A complete parts list for the venting system design or venting system.

(d)Manufacturer requirements — Gas Equipment Venting System Not Provided. When the manufacturer of a Product

Approved side wall horizontally vented gas fueled equipment does not provide the parts for venting the flue gases, but identifies “special venting systems,” the following requirements shall be satisfied by the manufacturer:

1.The referenced "special venting system" instructions shall be included with the appliance or equipment installation instructions; and

2.The “special venting systems” shall be Product Approved by the Board, and the instructions for that system shall include a parts list and detailed installation instructions.

(e)A copy of all installation instructions for all Product Approved side wall horizontally vented gas fueled equipment, all venting instructions, all parts lists for venting instructions, and/or all venting design

58D6002

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents What to do if YOU Smell GAS Natural Gas or Propane/LPG Milli-Volt ControlRead and Save These Instructions Contents Installer Owner Important Safety InformationImportant Safety Information Handle Here Product featuresHandle Door21 1 26 3 28 1 16 1 19 3 DimensionsMake sure you have received all parts What you will need for installationNatural Gas Product SpecificationsPropane / LPG Codes General Installation InformationAdequate Combustion and Ventilation AIR L1 = 151/2 Ft., L2 = 12 Ft., W = 12 Ft., H = 8 Ft Counter Cast Iron StoveSide View Corner Installation Wall InstallationClearances / Height Requirements Front ViewVF20 38½ VF30 Tested Minimum Alcove Dimensions Height FromClearances / Height Requirments WidthAsh Lip Control Door Removing Unit from CratePlastic Bag Pallet Hearth DoorManual Shutoff Gas Supply Inlet Valve Connecting the GASExplosion Checking GAS Pressure and connecting remote receiverConnecting directly to an unregulated Propane/L.P.G. tank can cause anElectrical Wiring Milli-volt LOG Placement Bend in Rock Wool Tray Rock Wood LOG PlacementThermocouple For Natural For LP Flame appearanceChecking pilot flame Milli-volt ControlMiddle Log Flame AppearanceChecking Burner Flame Operating InstructionsOff/Pilot/On Knob Optional Operating InstructionsMILLI-VOLT Control Lighting Instructions Cleaning and Servicing Operating Instructions and Cleaning and ServicingReplacement parts Description Qty Natural Propane Replacement Parts listBurner assembly VF20Failure to use only parts specifically Burner assembly VF30Accordance with these diagrams or Failure to position the parts58D0061 58D0056 Union Tee 43D018158D0193 58D0435Description Qty VF30 LogsSymptom Possible Cause Action TroubleshootingWhen con Carbon Monoxide Detector Requirements Limited Lifetime Warranty

VFCS20DNV, VFCS20DPV, VFCS30DPV, VFCS30DNV specifications

Monessen Hearth has long been synonymous with high-quality and efficient heating solutions, and their range of direct-vent gas fireplaces, including the VFCS30DNV, VFCS30DPV, VFCS20DPV, and VFCS20DNV models, exemplify this commitment. These fireplaces offer both aesthetic appeal and advanced technology, making them suitable for any home.

One of the key features of the VFCS series is its impressive heat output. The VFCS30DNV and VFCS30DPV are designed to deliver substantial warmth, making them ideal for larger spaces. With a heat output of up to 30,000 BTUs, these models ensure consistent and comfortable heating during the cold months. The VFCS20 variants, while slightly smaller, still provide a robust performance with a maximum output of 20,000 BTUs, making them perfect for cozy living rooms or smaller areas.

In terms of design, these fireplaces are incredibly versatile, featuring sleek and modern aesthetic options. The VFCS models come with a wide viewing area, framed with stylish surrounds, which allows for an expansive view of the mesmerizing flame patterns. Additionally, they offer a choice of interior finishes like traditional brick or contemporary black, letting homeowners customize their fireplace to match their interior décor.

Incorporating advanced technology, these fireplaces use a direct vent system, ensuring efficient combustion and optimal heat distribution. This system allows for the safe venting of gases outside, creating a cleaner and healthier indoor atmosphere. The fireplaces operate on natural gas or propane, providing flexibility based on the homeowner's preferences and availability.

Moreover, Monessen Hearth's VFCS models are equipped with user-friendly controls, enhancing the overall functionality. The optional remote control and wall switch make it easy to operate the fireplace, allowing users to adjust the flame height and heat output according to their comfort level without the need to leave their seat.

Energy efficiency is another hallmark of these fireplaces. With high-efficiency ratings, they provide significant savings on heating bills while delivering a cozy environment. The multi-functionality of the VFCS series also allows for the addition of decorative elements, such as glass media or logs, further enhancing the atmospheric appeal.

In summary, Monessen Hearth's VFCS30DNV, VFCS30DPV, VFCS20DPV, and VFCS20DNV models bring together aesthetics, efficiency, and advanced technology, making them an exceptional choice for anyone looking to add warmth and elegance to their home. Whether for heating a spacious area or a snug room, these direct-vent gas fireplaces meet a variety of needs with style and reliability.
Top Page Image Contents