Maintenance
6.Maintenance
6.1. Troubleshooting
PROBLEM
LIKELY CAUSE
SOLUTION
Conveyor doesn’t turn | Power off at circuit breaker | Reset circuit breaker | |
| Drive motor burn out | Replace drive motor | |
|
|
| |
| Obstruction in wash or rinse | Remove obstruction | |
| Micro switch on switch support | Replace or adjust | |
| bracket faulty or not making |
| |
| contact |
| |
| Conveyor not in position | Position properly | |
Excessive overspray from | Splash curtain not in position | Install or adjust | |
hood section |
|
| |
Washer running without any | Keep conveyor loaded with | ||
| |||
| glasses on conveyor | glasses | |
| Spray tubes fallen off hub | Ensure spray tube is pushed | |
|
| firmly on to hub connection | |
| Spray tubes plugged | Clear and clean with reamer, | |
|
| scraper, and brush | |
Lack of pressure in wash | No water in detergent tank | Ensure water supply is on | |
spray tubes |
| Ensure detergent tank stand | |
|
| pipe is in position | |
|
| Ensure the tank fill switch is in | |
|
| ||
|
| fills with water | |
|
| Ensure the float switch is | |
|
| activated by the float cam | |
|
| Ensure the tank fill solenoid is | |
|
| operational | |
| Obstruction in wash arm | Clear obstruction | |
|
|
| |
| Pump not operating | Check power supply to | |
|
| machine | |
|
| Check pump capacitor | |
|
| Replace pump if required | |
|
|
| |
| Pump operating but no pressure | Check condition of impeller | |
|
| and stub shaft | |
|
| Replace if needed | |
Lack of pressure in rinse | Rinse spray tubes dirty | Clean thoroughly with reamer, | |
spray tube |
| scraper, and brush provided | |
| Open valve | ||
| closed |
| |
| Low water pressure | Minimum 25PSI flow pressure | |
|
| required | |
MODEL | Page 8 |