Getting Started
2.2.Receiving and Installation
When you receive your new CMA-44, complete the assembly by installing the scrap tray assembly with its overflow chute, the two wrapper shields and the curtain rods, which are shipped inside the machine. After the box has been removed from the machine, remove the left and right stainless steel wrapper shields and bolt them in place with the nuts and bolts provided. The wrapper shield with the extra curtain clamps mounts onto the dirty end of the machine. Next, mount the scrap tray assembly and overflow chute into position (see section 2.3.4 Scrap Tray Assembly and Overflow Chute Installation).
All of the spray arms should be inserted and in place over the wash tank compartments.
There are a total of four curtains used in the CMA-44; two are long- narrow, two are short- wide. The two long-narrow curtains have shorter rods than the other two curtains. The short rods hold the curtains at the entrance and exit of the machine.
The sketch below lists curtain positions 1 through 4.
CMA-44
2 
3
SHORT-
WIDE
CURTAINS
DISHMACHINE FRONT VIEW
MODEL CMA-44 Installation & Operation Manual Rev. 2 .15 10/18/07 | Page 4 |