CMA Dishmachines CMA-44 manual Rinse Pressure Regulator for detailed instructions

Getting Started

P/N 13505.12

205 RACKS (CMA-44H)

242 RACKS (CMA-44L)

P/N 13505.10

OLD Models

205 RACKS (CMA-44H)	167 RACKS (M-1)
B
	A
C
	242 RACKS (CMA-44L)
Figure 2.3.3b

4.On a 3-phase machine the water pump motors are also 3-phase and, depending on which terminal each phase is connected to, the motor can rotate in either direction. Check the direction of rotation by removing the dust cap on the back of the motor.

The motors must turn clockwise looking at the shaft from the back of each motor. To change the direction of rotation, switch any two power lead wires at the motor.

5.The machine must be running to set the pressure regulator. While the machine is in the FINAL RINSE CYCLE, adjust the pressure regulator to 20 PSI. See section

3.1.3 Rinse Pressure Regulator for detailed instructions.

MODEL CMA-44 Installation & Operation Manual Rev. 2 .15 10/18/07 Page 7