Char-Broil 4654870 On upper lip of insulation bowl, Lid 772, Tighten wing nut Lid, Grill Bottom

Page 7

3		Lower end of lid hanger bracket must rest
3		on upper lip of insulation bowl.
		on upper lip of insulation bowl.
	Lid	772
		772
MISC Bag

Repeat for all three holes

NOTE:

Adjust insulation bowl as necessary to align upper lip with brackets.

Tighten wing nut.

Align rectangular slots

Fold flaps inwards and

upwards (90 degrees) so they are horizontal.

Push insulation bowl tabs C down and under to

temporarily hold bowl in place while you work.

4654870 • 7

Image 7

Contents Assembly Manual Grill Service Center Safety Symbols Table Of ContentsIf you must use an extension cord for your safety General SafetyExtension Cord Use and Safety Ground Fault Interrupter#10 Fasteners Bag Parts List ModelMisc. Fasteners Bag 302 Before Beginning AssemblyAttach wing nut do not Tighten until after Step 249 Tighten wing nut Lid On upper lip of insulation bowlLid 772 Lid208 302 094 Use 10 or less Ceramic Nuts as Shown.208Briquet Grate Push insulation side flaps Down flush with bowl Orient heating element so that the notch is on TOPBracket ElementTop View Turning Grill On Use and Care of Your GrillBefore First Use of Grill Before Each Use of GrillGrilling Cleaning Electrical Controller and Heating Element BracketCleaning Your Grill Food SafetyProblem Explanation / Possible Cause Prevention / Solution TroubleshootingInitial Settings Cooking Chart Cooking ZonesKnow Your Grill