Edge Craft 120 manual Normal Maintenance, Service

NORMAL MAINTENANCE

No lubrication is required for any moving parts, motor, bearings or sharpening surfaces. There is no need for water on abrasives. The exterior of the sharpener may be cleaned by carefully wiping with a damp cloth. Do not use detergents or abrasives.

Once a year or so, as needed, you can remove metal dust that will accumulate inside the sharp- ener from repeated sharpenings. Remove the small rectangular clean-out cover (Figure 14) that covers an opening on the underside of the sharpener. You will find metal particles adhered to a magnet attached to the inside of that cover. Simply rub off or brush off accumulated filings from the magnet with a paper towel or tooth brush and reinsert the cover in the opening. If larger amounts of metal dust have been created or if the Stage 3 disk has been cleaned (using the cleaning/dressing means), you can shake out any remaining dust through the bottom opening when the cover is removed. After cleaning, replace the cover securely with its magnet in place.

Figure 14. Clean-out cover.

SERVICE

In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory where the cost of repair can be estimated before the repair is undertaken. Outside the USA, contact your retailer or national distributor.

Please include your return address, daytime telephone number and a brief description of the problem or damage on a separate sheet inside the box. Retain a shipping receipt as evidence of shipment and as your protection against loss in shipment.

®

Send your sharpener (postage prepaid) to: EdgeCraft Corporation

825 Southwood Road

Avondale, PA 19311

Customer Service 1-800-342-3255 or 610-268-0500

Assembled in the U.S.A. U.S.Patents4,807,399, 5,611,726, 6,012,971, 6,113,476, 6,267,652,and D,409,891. Other U.S. and foreign patents pending.

Chef’sChoice®, EdgeCraft®, Diamond Hone®, and the overall design of this product are registered trademarks of EdgeCraft Corporation, Avondale, PA.

C128200 www.edgecraft.com J0550

12