Emerilware 20010 manual Refitting the central unit, Remove the seal

Page 10

C A R E A N D C L E A N I N G

Refitting the central unit:

•Put the lid on your work surface in the position indicated on. Place the unit back into place. See Fig. 9.

•Check that the open/close knob is in the "Open" position .

•Push the moving parts (flaps) of the lid outwards. See Fig. 9.

•Position the central unit on the lid. Turn over the whole lid while holding the open/close knob. Then use a coin to tighten the nut inside the lid.

Remove the seal

•Remove the seal from the lid and clean with a sponge in warm water and liquid dishwashing detergent.

•To refit the lid seal: turn the lid over so that the interior surface is visible and fit the seal as shown in the diagrams. See Fig. 10 and 11.

•Change the seal if it is cracked or nicked, or if the seal is no longer effective.

Tips to help keep the cooker in perfect condition:

• Avoid overheating the pan while empty.

Brown stains and scratches may appear after prolonged use, but these will not affect the cooker's performance.

Fig 9

Fig 10

Fig 11

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents One Pot P O R T a N T S a F E G U a R D S B L E O F C O N T E N T S Always put at least 1 cup 250 ml liquid in the One PotT R O D U C T I O N Take care to avoid the jet of steam Steam escaping from the steam vent is very hotDo not force open Use protective mitts and only touch the handles and knobsFeatures E R a T I N G I N S T R U C T I O N SO D P R E PA R a T I O N I N S T R U C T I O N S F E T Y F E a T U R E S L P F U L H I N T SHelpful Hints R E a N D C L E a N I N G Maintenance of the LidPan Exterior and Lid Remove the seal Refitting the central unitTips to help keep the cooker in perfect condition Troubleshooting M I T E D O N E Y E a R W a R R a N T Y
Top Page Image Contents