Viper 5901 manual Additional remote start features, Manual Transmission

Page 28

Additional remote start features

Manual Transmission

If the vehicle has a manual transmission the proper steps must be fol- lowed before leaving the parked vehicle or the remote start feature is disabled.

1.Make sure the engine is running and the doors on the vehicle are closed.

2.Put the transmission in neutral.

3.Press on the brake in the vehicle.

4.Apply the emergency brake.

5.Release the brake.

Note: Pressing the brake pedal again after this step will disable the remote start feature.

6.Within 15 seconds activate the remote start from the remote.

7.The parking lights flash 5-times confirming that the remote start is active. If the parking lights do not flash 5-times, then repeat steps 1 - 6.

8.Turn off the ignition (the car stays running when key is turned off).

9.Exit the vehicle.

10.Arm the alarm (the vehicle should shut off when arming the sys- tem).

You can now remote start the vehicle. If a door is opened or the alarm is triggered before the next remote start activation the system will not remote start.

Note: To enable Valet take-over with a manual transmission, open the door and enter into manual transmission mode, as described above. The parking lights flash one-time when entering Valet take-over. Once you exit the vehicle you can lock the system and the car will remain

28	© 2008 Directed Electronics. All rights reserved.

Image 28

Contents Responder LC Model Security and Remote Start Owner’s Guide Page Contents Way remote Remote Controls Government regulationsControl Center Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Your warranty What is includedImportant information Replacement remote controls Out of Range Notification System maintenanceCharging the Battery Low battery indicatorBattery Replacement Multi-car control capabilityTwo Way Remote One Way RemoteResponder LC 2-Way Transmitter configuration LC 1-way companionDirected Electronics. All rights reserved If errors are found when arming Using the systemArm Disarm Command Press one time to DisarmRemote Start Valet Take-Over Valet mode Function shiftPress Feedback UnlockCar finder Cabin temperature Additional arming features Arm FeaturesWhile the system is armed Silent armInner zone To disarm the system without a remote control Sponse will reset System override Modified Arming Modes Will beep once Silent Mode 2 Turning off the siren Disarm FeaturesSilent disarm Additional remote start features Manual TransmissionTimer mode Turbo Timer mode Runtime reset Runtime checkRemote will respond with error tone Enter the MTS procedureRear defogger Smart startDirected Electronics. All rights reserved Auxiliary features AuxFeedback The screen will show a text of the item activated Feedback Text will display the item activatedRemote control feature programming Remote setup options OffMenu option descriptions Remote start display Clock, temperature or runtime Pair Remote Mode Sensor adjustDemo Modes Starter anti-grind circuitry Safety featuresDisabling the remote start system Last trigger DiagnosticsArming Disarming System status chirpsInterpreting zone diagnostics Table of zonesNuisance prevention circuitry Remote StartOwner recognition Rapid resume logicSystem Power saver modeWay remote Programming options Directed Electronics. All rights reserved Security & convenience expansions Directed Electronics. All rights reserved Glossary of terms To the vehicle or glass LCD layout ALLThis feature is not available Quick reference guide Location of Shutdown Toggle Switch Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics