Note: Bypass Notification does not occur when the system is in Silent Mode or if the notification chirps have been programmed off by the installer.
➢Disarming
Extra chirps heard when disarming the system are the Tamper Alert. If four chirps are heard when disarming the system, then the security system was triggered in your absence.
If five chirps are heard when disarming the system, the system was triggered so many times that the Nuisance Protection® Circuitry has bypassed the intended zone. In either case, the status LED will indicate which zone was involved (see Table of Zones).
The security system will retain this information in its memory, and chirp four or five times each time it is disarmed, until the next time that the ignition is turned on.
Note concerning low battery alert: When the batteries in the remote are low the alarm will give an additional chirp when disarming to let you know its time to change the battery in the remote.
➢System status chirps
The siren will chirp when arming/disarming the system. The pattern of chirps will audibly report the system’s status as described below.
Action | Number of Chirps | Description |
Arm | 1 | System armed |
Arm | 1 | System armed with bypass notification |
Disarm | 2 | System disarmed |
42 | © 2008 Directed Electronics. All rights reserved. |