Jura Capresso IMPRESSA E60 manual Safety instructions, Safety precautions, Checking the fuse

Page 7

2. Safety instructions

2.1 Warnings

Children are unaware of the dangers that electrical machines can represent; for this reason, children should never be left unsuper- vised with electrical machines.

This machine should only be used by people who have read these instructions.

Never use a faulty machine or one with a damaged power cable.

Never immerse the machine in water.

2.2 Safety precautions

Never subject the machine to the effects of the weather (rain, snow, frost) and never operate it with wet hands.

Place your machine on a solid level surface. Never leave it on a surface which is warm or hot (hob etc.). Choose a location which is inaccessible for children or for pets.

Always pull the plug out if you are away for a long time (holi- days etc.).

Always pull the plug out first before cleaning.

When pulling the plug out, never tug on the cord or on the machine itself.

Never repair or open the machine yourself. All repairs should be done by authorised service centres only using original Jura spare parts and accessories.

The machine is connected to the mains power socket via an electric cable. Make sure that nobody trips over it and pulls the machine down. Keep children and pets well away from the machine.

Never put the machine or even parts of it into the dishwasher.

Choose a place with a good circulation of air in order to prevent the machine from overheating.

If you use de-scaling agents containing acid, remove any splas- hes and drips on sensitive surfaces, in particular natural stone and timber surfaces and/or take corresponding precautionary measures.

3. Preparation of the machine

3.1 Checking the mains voltage

The machine is set to the correct voltage before leaving our factory. Ensure that your mains voltage corresponds to the details quoted on the rating plate attached to the bottom of the machine.

3.2 Checking the fuse

The machine is designed for a current of 10 Amps. Check that the fuse used matches this.

3.3 Filling the water tank

E

 

Remove the water tank and rinse it out well with cold tap water.

Then fill the water tank and put it back into the machine. Ensure that the tank engages properly (Fig. 1).

Only use fresh, cold water. Never fill with milk, mineral water or other fluids. You can also add water without removing the tank. Simply lift the lid up and pour in water from above with a vessel. Close the lid again.

3.4 Adding coffee beans

Lift up the cover of the bean container (11).

Clean out any dirt or foreign objects from the bean container.

Pour coffee beans into the bean container and close the cover again.

7

Image 7
Contents Impressa E40 Impressa E60 Impressa E65 Jura Impressa E40/E60/E65 Page Operating elements Jura Impressa E40/E60/E65 Contents Important information for the user Symbols meanDescription Checking the fuse Safety instructionsSafety precautions Preparation of the machine Checking the mains voltageAdjusting the water hardness Adjusting the grinderFirst start of operation Fill system with water Adjustable automatic switch-offDrawing off espresso/strong coffee Adjusting the water quantityRinsing the machine Drawing off espresso/normal coffeeDrawing off hot water Switching machine offDrawing off steam Return to stand-byNo drip tray Care and maintenance Fill waterClean unit Empty grounds containerRegular service General cleaning instructionsReplace filter Empty system CleaningDescalcifying Tips for perfect coffee DisposalDisplay Cause Action MessagesProblem Cause Action ProblemsLegal information Technical data