Jura Capresso IMPRESSA X7 manual Messages, Problems

24. Messages

Cause	Action
FILL WATER TANK	The tank is empty	Top up with water
	The water level display in the tank has jammed	Empty tank, rinse out and replace when it has
		been filled
	The tank is scaled; the water level display is	Remove the tank, de-scale it, rinse well,
	jammed	fill and put in again
FILL COFFEE BEANS	The bean container is empty	Fill up with beans
	Although beans have been filled, the display	Draw off a cup of coffee.
	does not go off	“FILL BEANS” only goes off after a draw-off
	A foreign body has got jammed	Remove the foreign body as described in	E
		Section 16.8 “Removing foreign objects”
EMPTY DRAWER	The grounds container is full	Remove the tray, empty the grounds container,
		replace the tray
	The display appears after	Leave the machine switched on while the grounds
	only a few cups	container is emptied.
		The counter is only reset if the machine is
		switched on.
DRIP TRAY MISSING	The drip tray has not locked in properly	Position the tray correctly.
EMPTY DRIP TRAY	The drip tray is full	Carefully remove the tray, empty it, rinse it out
		and replace it
	The display does not go off despite the tray	Remove the tray, clean the metal contacts,
	being emptied	see Chapter 16.11
CLEANING NECESSARY	220 draw-offs or 180 rinsings have been done	Carry out cleaning according to Chapter 19
	The display does not go off	Do the cleaning once more;
	despite the cleaning	but do not add a cleaning tablet this time
DECALCIFYING	The machine must be de-scaled	Carry out de-scaling as described in Chapter 20
NECESSARY	The display does not go off	De-scale the machine again; this time only with
	despite the de-scaling	water, without de-scaling agent
MALFUNCTION	Various causes	Call the office trader

25. Problems

Problems	Cause	Action
Coffee only drips out	– powder too fine	– adjust grinder to a coarser grinding
when drawing off		– run one or two rinse programmes.
		– If the results are no better, clean
		– the machine.
Coffee flow is stopped after	– not enough powder in the system	– draw off one cup of coffee
the pre-brew
Grinder is very noisy	– foreign object in the grinder	– refer to Chapter 16.8
Not enough froth when	– Cappuccino blocked	– carry out a Cappuccino cleaning
frothing milk		– (refer to Chapter 17)
Device cannot be	– Main switch (Fig. 1/II) not switched on	– switch on
switched on with the
ON/OFF switch	– Flat not engaged properly	– close flap

If the messages or problems nevertheless still persist, please get in touch with your dealer or directly with the firm of Jura Elektroapparate AG.

13